SIZZIX BIGkick Manual De Instrucciones

The Sizzix BIGkick™ is exactly what crafters have been looking
®
for – a versatile, easy to use and affordable multipurpose creative
system. Designed to cut and emboss for creating unlimited fun
projects. Using the Sizzix Originals™, Bigz™, Sizzlits
and Embosslits™ Dies as well as Simple Impressions™ Embossing
Folders, crafters can now express their creative voice in minutes.
Start unleashing the limitless possibilities of your BIGkick to
create a combination of dazzling designs.
Assembly Instructions
Before attaching handle, remove protective cap on crank shaft and
discard. Then attach handle by sliding washer over hex screw and
insert through handle and into crank shaft. Tighten hex screw with
hex wrench provided with handle kit. Press end plug over hex screw
until firmly sealed.
Using an Originals
Paper
Die
Place an Originals or Bigz Die on a Cutting Pad with foam side
up. Place paper or desired material to be cut on top of the die.
Place the second Cutting Pad on top of the paper or material to
create a "sandwich."
(Do not use the Multipurpose Platform
when die-cutting with Originals and Bigz Dies.)
Slide the sandwich into the opening of the BIGkick. Note the
rotation of the handle and continue to rotate it in the same
direction until the sandwich has passed through the opening of
the rollers. Remove the sandwich from BIGkick. Your die-cut
shape is ready to use!
TM
TM
, Clearlits™
®
Crank Shaft
Washer
Hex Screw
End Plug
Handle
Protective Cap
or Bigz Die
™ ™
Cutting Pads
"Sandwich"
Using a Sizzlits or Clearlits
®
Paper
Die
Multipurpose Platform
(Tab 1)
Place Sizzlits Die onto a Cutting Pad with foam side up. Place
paper over the die. Place another Cutting Pad over the paper to
create a "sandwich." For Clearlits Die, place die over photo or
material so that the area to be cut shows through the die.
Then place photo or material and die between Cutting Pads to
make sandwich.
Multipurpose Platform
Place sandwich on Multipurpose Platform and slide Platform
into opening of BIGkick. Note the rotation of the handle and
continue to rotate it in the same direction until the Platform
has passed through the opening and the rollers. Remove
Platform from BIGkick. Your die-cut shape is ready to use!
Using a Simple Impressions
Embossing Folder or Embosslits
Simple
Impressions
Embossing
Folder
With Simple Impressions Embossing Folder or Embosslits Die
open, insert paper, foil or other embossable material, then
close like a book.
Simple
Impressions
Embossing
Folder
Multipurpose Platform
(Use no Multipurpose Platform Tabs with 2 1/2" Folders.)
Multipurpose Platform
(Use Multipurpose Platform Tab 1 with Embosslits Dies
and Embossing Folders 4" and wider.)
Place Cutting Pad above and below the closed Folder to
create a "sandwich."
Die
™
Cutting
Pads
"Sandwich"
™
Die
™
Paper
Embosslits Die
Cutting
Pads
4" Embossing
Folder