SIZZIX Big Shot Manual Del Usuario

The Sizzix Big Shot™ Machine is
®
exactly what crafters have been looking
for – a versatile, easy to use and
affordable multipurpose creative
system. It is designed to cut and
emboss for creating unlimited fun
projects. Using the Sizzix Originals™,
Bigz™, Sizzlits , Clearlits™ and
®
Embosslits™ Dies, as well as Simple
Impressions Embossing Folders,
®
Textured Impressions™ Embossing
Folders and Texturz™ Texture Plates,
crafters can now express their
creativity in minutes. Start unleashing
the limitless possibilities of your Big
Shot to create a combination of
dazzling designs.
Using a Sizzlits or Clearlits Die
Paper
Die
Multipurpose Platform
(Tab 1)
Place Sizzlits Die onto a Cutting Pad with foam side up. Place
paper over the die. Place another Cutting Pad over the paper to
create a "sandwich." For Clearlits Die, place die over photo or
material so that the area to be cut shows through the die.
Then place photo or material and die between Cutting Pads to
make sandwich.
Multipurpose Platform
Place sandwich on Multipurpose Platform and slide Platform
into opening of Big Shot. Note the rotation of the handle and
continue to rotate it in the same direction until the Platform
has passed through the opening and the rollers. Remove
Platform from Big Shot. Your die-cut shape is ready to use!
®
Cutting
Pads
"Sandwich"
IMPORTANT SAFETY INSTRUCTIONS
WARNING
– When using this product, basic
precautions should always be followed, including the following:
a) Read all the instructions before using the appliance.
b) To reduce the risk of injury, close supervision is necessary
when this machine is used near children.
c) Do not contact moving parts.
d) Only use attachments recommended or sold by the
manufacturer.
e) Do not use outdoors.
f) Always place and operate this machine on a clean, flat
surface.
g) PINCH HAZARD. AVOID ROLLERS.
h) DO NOT OVERLOAD THE MACHINE.
i) CUTTING HAZARD. AVOID CONTACT WITH THE DIE
BLADE.
j) ADULT SUPERVISION OF CHILDREN RECOMMENDED.
SAVE THESE INSTRUCTIONS
Assembly Instructions
Washer
Crank Shaft
Before attaching handle, remove protective cap on crank shaft and
discard. Then attach handle by sliding washer over hex screw and
inserting through handle and into crank shaft. Tighten hex screw
with hex wrench provided with handle kit. Press end plug over hex
screw until firmly sealed.
Using a Simple Impressions Embossing Folder,
Textured Impressions Embossing Folder
or Embosslits Die
Simple
Impressions
Embossing
Folder
With Simple Impressions Embossing Folder, Textured
Impressions Embossing Folder or Embosslits Die open, insert
paper, foil or other embossable material, then close like a book.
Simple
Impressions
Embossing
Folder
Multipurpose Platform
(Use no Multipurpose Platform Tabs with 2 1/2" Folders.)
Multipurpose Platform
(Use Multipurpose Platform Tab 1 with Embosslits Dies
and Embossing Folders 4" and wider.)
Place Cutting Pad above and below the closed Folder to
create a "sandwich."
Hex Screw
End Plug
Handle
Protective Cap
Paper
Cutting
Pads
4" Embossing
Folder