BH FITNESS H872N Manual Del Usuario página 9

ELECTRONIC MONITOR
When the machine is switched on the
monitor will display U1 in the centre of
the screen. Select the user, between
U1-U4, using the ▲/▼keys and then
press the ENTER/MODE key.
To give you greater control over the
exercise, this
provides simultaneous read-outs of
speed/rpm, distance, exercise time,
calories burnt and pulse rate.
STARTING
The monitor
automatically and begin at 45 rpm (on
this model equivalent to approximately
6 km/h on the monitor) and switch off
if this speed is not reached or if
cancelled.
Optionally, if you wish to have the
monitor on constantly you can plug the
adapter (9V),
machine, into the mains socket (220 V
– 240 V) and the jack on the adapter
into the socket at the bottom rear of
the machine.
The screen
automatically
exercising on program "U1" (User 1).
Select the user, between U1-U4, using
the ▲/▼keys and then press the
ENTER/MODE key, after which the
programs available on the monitor will
appear.
If at any time during exercise you
press the START/STOP button then
all of the unit's functions will stop.
Pressing the START/STOP button
again will restart the machine.
When working without an adapter, the
monitor switches off automatically as
electronic monitor
will switch
supplied with
will switch
when you
English
soon as you stop exercising. When
working with the adapter, the monitor
will switch off after the machine has
been idle for 4 minutes.
Important:
components in special containers, Fig.
1.
MONITOR FUNCTIONS
This electronic unit has seven function
keys: RECOVERY, FAN ON/OFF,
START
ENTER/MODE; ▲; ▼. PULSE / THR
on
is display at the top of the monitor.
The
simultaneously display the selected
program
windows at the bottom of the display
that indicate the SPEED / RPM; TIME;
DISTANCE; WATTS / CALORIES.
This monitor also has 1 manual
the
program, 12 pre-set exertion level
programs; 1 user defined program; 4
Heart Rate Control programs and 1
steady watt rate program.
With the monitor either stopped or
on
working the SPEED / RPM and TIME /
begin
CALORIES and DISTANCE / WATT
windows give alternate displays every
5 seconds.
STARTING THE FAN
To switch the fan on or off, press the
FAN ON/OFF key.
Whenever you finish your exercise,
make sure that the fan is switched off.
By pressing the RESET key the
monitor will enter program selection
status. Holding the RESET key down
for 4 seconds will reset the monitor
allowing you to select a new user by
9
Deposit
/ STOP;
centre of the
level. There
electronic
RESET,
screen will
are three