Cadet Energy Plus CE163T Manual Del Usuario página 5

INSTALLATION INSTRUCTIONS (continued)
__________________________
How do I insert the heater assembly into the wall can?
Install Heater Assembly
STEP 1
Turn heater assembly so that the front is facing the floor (element down with motor facing up). You can then rest the bottom edge of the
heater assembly on the bottom of the wall can while supporting the edge closest to you.
Connect the supply wires to the heater wires with wire connectors (not included). (See Figure 5 or Figure 6). Now rotate heater assem-
bly into wall can so that the bottom edge drops into the half round slots in bottom lip of wall can (See Figure 7).
IMPORTANT: Push wires into bottom and left side of wall can during insertion. Be sure supply wires are not caught between motor and
wall can.
After confirming that the bottom edge of heater is positioned in the slots in bottom lip of wall can, attach assembly at top with screw
provided.
STEP 2 Install Grill
Align digital display with grill cutout before tightening with grill screws provided. Do not overtighten (See Figure 8).
Installation
STEP 3
Turn electrical power back on at the main disconnect panel. WAIT 10-15 seconds for heater to power-up before pushing any buttons.
The CE163T and CE083T Energy Plus heaters are equipped with a smart sensor that will auto-adjust to your voltage supply. No need
to worry about whether you have 120 or 240 volts.
If the heater has been properly installed:
Display will read "88" for a moment; then flash the temperature set point if in HEAT mode; or 0, 1, 2, or 3 if in FAN ONLY mode.
After approximately 10 seconds, room temperature will be displayed. Proceed to OPERATING INSTRUCTIONS.
If the CE162T or CE168T is installed to the incorrect voltage, a Fault Code will display (See Fault Codes, page 7).
Figure 5
(Single Heater 120/208/240V)
Wiring
to Other
Heater
Figure 6
(Multiple Heaters on a branch circuit,
208 or 240V ONLY)
__________________________
Part Two
Field
Wiring to
Breaker
Figure 7
Figure 8
Page 5