Virtus 70/80 BRE Serie Instalación, Uso, Mantenimiento página 31

GAS BRATT PAN
REPLACING THE GAS VALVE, THE PILOT BURNER,
THE THERMOCOUPLE, THE ELECTRIC IGNITION,
AND THE IGNITER.
- Remove the bottom front panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE BURNER
- Remove the control panel and internal guards.
- Lift completely the tank and unscrew the burner
fixing screws.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE TEMPERATURE THERMOSTAT, THE
CONTROL KNOB, THE INDICATOR LAMP AND THE
SAFETY THERMOSTAT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
PAN LIFTING MICROSWITCH
- Remove the bottom front panel.
- Disconnect the device's electrical connections.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
PAN MOVEMENT MOTOR
Remove the bottom front panel.
Lower the well completely.
Disconnect the device's electrical connections.
Detach the connection with the pan lifting "bolt".
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
SCREW NUTS AND MANUAL PAN MOVEMENT
SYSTEM (BOLT)
Remove the bottom front panel.
Lift the pan completely, locking it fi rmly in that
position (e.g.with a bar).
Important: measure how far tightened the "bolt" is
with regard to the screw nut before removing the
components.
Disconnect the "bolt" from the handwheel shaft.
Undo the screw nut fi xings.
Remove and replace the component.
Reassemble all parts. For assembly, proceed in
reverse order.
ELECTRIC BRATT PAN
REPLACING THE HEATING ELEMENT
- Remove the bottom front panel.
- Remove the box and the cover of the element
terminals.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
REPLACING THE TEMPERATURE THERMOSTAT, THE
CONTROL KNOB, THE INDICATOR LAMP AND THE
SAFETY THERMOSTAT
- Remove the control panel.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
PAN LIFTING MICROSWITCH
- Remove the bottom front panel.
- Disconnect the device's electrical connections.
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in
reverse order.
PAN MOVEMENT MOTOR
30