Thermador PROFESSIONAL PCG304G Manual De Instalación página 10

12"
(305 mm)
½"
(12.7 mm)
Side
flange
2" (51 mm) min.
from the rear of
unit to the back
wall.
NOTE: Unit is shown with Low Back guard (purchased separately).
11 " (18 mm)
/
16
Notch Depth
Front projects outward 9/16" (14 mm) as
shown from standard 24"-deep base.
Figure 6: Projecting from Cabinet Front
* Low Back
(purchased separately)
* Low Back required when there is less than
12" (305 mm) horizontal clearance from
back of cooktop to combustible material.
With more than 12" (305 mm) of clearance,
the Flush Island Trim may be used.
Cabinet face for installation with projecting control panel.
Cabinet face for installation with flush control panel.
3-Prong grounding type receptacle
connected to a properly grounded,
dedicated and polarized electrical supply
rated at 120VAC, 10 Amps, (or 15A*)
Single Phase, 60 HZ.
9 " (14 mm)
/
16
"
3
25 /
8
(645 mm)
"
5
23
/
16
(592 mm)
as defined in the "National Fuel Gas Code" (ANSI Z223.1, Current Edition).
Clearances from non-combustible materials are not part of the ANSI Z21.1
scope and are not certified by CSA. Clearances of less than 12" (305 mm)
must be approved by the local codes and/or by the local authority having
jurisdiction.
1¼" (32 mm)
Notch Depth
Front flush with cabinets; minimum of 24
(624 mm) cabinet depth required.
"
5
7 /
8
(194 mm)
1¼"
(32 mm)
Figure 5: Side View of Rangetop
9 / 16 "
Figure 7: Flush to Cabinet Front
English 7