Know Your Trimmer; Assembly Instructions - Craftsman WEEDWACKER Manual Del Operador

KNOW YOUR TRIMMER

Muffler
Shaft Grip
On/Off Stop
Control
D-Handle
Craftsman®
Convertible™
Coupler
Shaft
Housing
Trimmer
Attachment
HassleFree™
Oil Fill Plug
Spark Plug
Fuel
Cap
Cold
Starting
Lever
Starter
Rope
Grip
Throttle
Control
Primer
Air Filter
Bulb
Cover
Line
Cutting
Blade
Cutting
Attachment Shield

ASSEMBLY INSTRUCTIONS

WARNING:
UNTIL THE D-HANDLE HAS BEEN ROTATED INTO
OPERATING POSITION (Fig. 1).
ADJUSTING THE D-HANDLE
1. Loosen the screws on the D-handle (Fig. 1).
On/Off Stop Control
Shaft Grip
Minimum 6 Inches
(15.24 cm)
D-Handle
2. While holding the unit in the
operating position (Fig. 2), position
the D-handle to the location that
provides you the best grip.
3. Tighten the clamp screws evenly,
until the D-handle is secure.
INSTALL LINE TRIMMER
ATTACHMENT
NOTE: To make installation easier, place
the unit on the ground or on a
workbench.
1. Turn knob counterclockwise to loosen
coupler (Fig. 15, p. 8).
2. While firmly holding attachment, push
it straight into the coupler until the
release button snaps into the primary
hole (Fig. 16, p. 8).
NOTE: Aligning the release button with the guide recess (Fig. 16,
p. 8) will help installation.
3. Turn the knob clockwise to tighten.
LINE TRIMMER APPLICATIONS
Cutting grass and light weeds; edging; and decorative trimming
around trees, fences, etc.
5
DO NOT ATTEMPT TO USE THIS UNIT
(4) Screws
Shaft
Housing
Bottom Clamp
Fig. 1
Fig. 2