Maintenance And Repair Instructions; Maintenance Schedule - Craftsman WEEDWACKER Manual Del Operador

LINE REPLACEMENT
for Hassle-Free™ Cutting Head
WARNING:
Do not remove or alter the line cutting
blade assembly. Excessive line length will make the
clutch overheat. This may lead to serious personal injury
or damage to the unit.
Always use Craftsman® Hassle-Free™ XTRA QUIET Spiral Line.
Choose the line size best suited for the job at hand. Red colored
line is designed for cutting grass and small weeds. Black colored
line is designed for cutting larger weeds and light brush.
NOTE: Before inserting new line into the holes in the cutting head,
identify the proper holes. Follow directions as shown on the
line glide plate. Do Not attempt to remove the cutting head
from the unit when replacing line.
1. Remove the old line and line glide
plate from the cutting head.
2. Clean entire surface of cut-ting
head. Note positions "A" and "B"
on the cutting head.
3. Reinstall line glide plate (Fig. 15).
Align arrow with:
"A" when using medium (red) or
large (black) line, or
"B" when using lines with diameters
smaller than medium (red) line
NOTE: Line glide plate must be reinstalled in cutting head before
inserting new line.
WARNING:
To prevent serious injury, never perform
maintenance or repairs with unit running. Always
service and repair a cool unit. Disconnect the spark
plug wire to ensure that the unit cannot start.
Perform these required maintenance procedures at the frequency
stated in the table. These procedures should also be a part of any
seasonal tune-up.
NOTE: Some maintenance procedures may require special tools or
skills. If you are unsure about these procedures take your unit
to a Sears or other qualified service dealer.
FREQUENCY
Before starting engine
Every 10 hours
1st change at 10 hours
At 25 hours/every 25 hours
Every 50 hours
10 hours on new engine
Every 25 hours
Every 25 hours

MAINTENANCE AND REPAIR INSTRUCTIONS

Line Glide
Cutting
Plate Arrow
Head
Fig. 15
• MAINTENANCE SCHEDULE •
MAINTENANCE REQUIRED
Fill fuel tank with fresh fuel
Check oil
Clean and re-oil air filter
Change oil
Change oil
Clean spark arrestor
Check rocker arm to valve clearance and adjust
Check rocker arm to valve clearance and adjust
Check spark plug condition and gap
4. Insert both ends of your line
through the proper holes in
the side of the cutting head
(Fig. 16).
5. Pull the line and make sure the
line is against the hub and is
fully extended through the
positioning tunnels (Fig. 17).
6. Correctly installed line will be
the same length on both
sides.
NOTE: Do not rest the Hassle-
Free™ Cutting Head on
the ground while the unit
is running.
Some line breakage will occur
from:
• Entanglement with foreign
matter
• Normal line fatigue
• Attempting to cut thick, stalky weeds
• Forcing the line into objects such as walls or fence posts
NOTE: Maintenance, replacement, or repair of the emission control
devices and system may be performed by a Sears or other
qualified service dealer.
In order to assure peak performance of your engine, inspection of
the engine exhaust port may be necessary after 50 hours of
operation. If you notice lost RPM, poor performance or general lack
of acceleration, this service may be required. If you feel your engine
is in need of this inspection, refer service to a Sears or other qualified
service dealer for repair. DO NOT attempt to perform this process
yourself as engine damage may result from contaminants involved in
the cleaning process for the port.
9
Positioning
Tunnel
Fig. 16
Line against
the hub
Positioning
Tunnel
Fig. 17
SEE
p. 6
p. 10
p. 11
p. 10
p. 10
p. 13
p. 12
p. 12
p. 12