V2 VEO-RFE Serie Manual De Instrucciones página 24

PROGRAMMING THE UPPER POSITION OF
THE END-OF-STROKE
To set the upper position of the end-of-stroke sensor on a
roll-up shutter equipped with lock on the upper side it is
necessary to use a remote control previously stored and
proceed as follows:
1. Supply power only to the control unit to be programmed
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 3 lights up with solid
light and the others flash
4. Press and hold down the UP+DOWN keys until the motor
moves in both directions which confirms it is entering the
programming phase
5. Release the keys, the motor stops
6. Press the UP key: the roll-up shutter rises at a normal speed
7. Once in contact with the upper lock, it stops and memorizes
the position
8. To exit the programming mode press the STOP key
To set the upper position of the end-of-stroke sensor on a
roll-up shutter equipped without lock on the upper side it
is necessary to use a remote control previously stored and
proceed as follows:
Repeat points 1,2,3,4,5 previously described
6. Bring the roll-up shutter to the upper position desired using
the UP and DOWN keys. To regulate it precisely, press the
UP+DOWN key when the motor is close to the end-of-stroke:
the motor will start to move in jerks
7. Press the STOP button when the desired position is reached
8. To exit the programming mode press the STOP key
UPPER
POSITION
MIDDLE
POSITION
LOWER
POSITION
PROGRAMMING THE LOWER POSITION OF
THE END-OF-STROKE
To set the lower position of the end-of-stroke it is necessary
to use a remote control previously stored and proceed as
follows:
1. Supply power only to the control unit to be programmed
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 5 lights up with solid
light and the others flash
4. Press and hold down the UP+DOWN keys until the motor
moves in both directions which confirms it is entering the
programming phase
5. Release the keys, the motor stops
6. Bring the roll-up shutter to the LOWER position desired using
the UP or DOWN keys. To regulate it precisely, press the
UP+DOWN keys when the motor is close to the end-of-stroke:
the motor will start to move in jerks
7. Press the STOP button when the desired position is reached
8. To exit the programming mode press the STOP key
PROGRAMMING OF THE INTERMEDIATE
POSITION OF THE END-OF-STROKE
To set the intermediate position of the end-of-stroke it is
necessary to use a remote control previously stored and
proceed as follows:
1. Bring the roll-up shutter to the INTERMEDIATE position desired
2. Activate the ARTEMIS programming
3. Press the UP or DOWN keys until the LED 3 lights up with solid
light and the others flash
4. Press the UP+DOWN keys of the transmitter until the motor
confirms the storage of the intermediate position moving in
both directions for 1/2 seconds
5. Release the keys
6. To exit the programming mode press the STOP key
To bring the roll-up shutter to the intermediate position
press the STOP key for at least 3 seconds (when the motor
is stopped): the roll-up shutter moves until it reaches the
stored position.
To delete the intermediate position previously stored it is necessary
to use a remote control previously stored and proceed as follows:
Per cancellare la posizione intermedia è necessario avere a
disposizione un telecomando precedentemente memorizzato e
repeat the procedure just described.
- 24 -