Main Functions; Changing Settings - Indel B SW CUBE Instrucciones Para El Uso

SW CUBE 12V

7.1 - MAIN FUNCTIONS

- A rapid pressure on the button turns "CUBE" on and off.
When the device is on, the display always shows the last set temperature.
ON – OFF
- A pressure lasting > 1 second toggles between COLD MODE
relative icon lights up.
After shut down, when "CUBE" is turned on, the last setting is maintained.
Passage from COLD MODE
- Every time the button is touched, it cycles between the following modes: MIN, AUTO and MAX.
The relative icon lights up.
MIN
MAX
MODE
AUTO
- When the device is off, if you press the MODE button, you will activate the DEFERRED
ACTIVATION mode and the relative icon
after a certain number of hours have elapsed, shown on the display; the number of hours can be se
between 1 and 99 by using the TEMPERATURE
VENTILATION
- Each pressure (+ / -) corresponds to the increase or decrease of the ventilation speed: you can
choose between 6 different levels of ventilation. The display will show the selected level.
- When the device is off, if you press the (+ / -) button, you will activate only the ventilation.
TEMPERATURE
- Ad Each pressure (+ / -) corresponds to the increase or decrease of one degree of temperature:
from a minimum value of 17 to a maximum of 32. The display will show the selected temperature.

7.2 - CHANGING SETTINGS

WARNING: before changing any setting, carefully read the following note.
WARNING: changing the standard settings must be carried out only by qualified personnel. Any
change performed without the proper skills may cause damage to "CUBE" and/or to the vehicle.
In order to access the setting menu, you must press the
device is off.
In order to scroll between menus use the
buttons.
The values will be saved after a few moments without touching anything else.
You can exit from the menu by not touching any button.
SW_CUBE_12V_20-02-2019
to HOT MODE
This corresponds the lowest power setting of "CUBE" (lowest performance and lowest
compressor speed – the timer is set for a continued function of 6 hours, after which
"CUBE" deactivates itself automatically). (The timer can be modified with the
parameter- see the "change settings" section).
This corresponds to the highest power setting of "CUBE" (highest performance and
highest compressor speed - the timer is set for a continued function of 4 hours, after
which "CUBE" deactivates itself automatically). (The timer can be modified with the
parameter- see the "change settings" section).
The management is automatic (performance and compressor speed are managed
automatically based on the temperature required by the user and on the current
temperature - the timer is set for a continued function of 6 hours, after which "CUBE"
deactivates itself automatically). (The timer can be modified with the
the "change settings" section).
When in AUTO mode you press one of the VENTILATION
MAN mode.
(+ / -) buttons; in order to choose the desired values, use the
and back again is not managed automatically.
will light up: "CUBE" will turn itself on automatically
.
(+ / -) buttons
(+ / -) and (+) buttons at the same time while the
38
and HOT MODE . The
P0
P1
P0
parameter- see
buttons, you will pass into
(+ / -)