Slave Mode - JB Systems Light TWINBEAM COLOR Mk3 Manual De Instrucciones

ENGLISH
 Press the FUNC-button until the display shows AUt.
 Press the ENTER-button to confirm your choice.
The laser automatically runs a preprogrammed sequence.
You can connect several TWIN BEAM COLOR Mk3 Lasers together: just put the first unit of the chain in
the automatic effect mode and all other units in "Slave mode" (display shows "SLA") to make them all work
in perfect sync!

3) SLAVE MODE:

The laser follows the instructions given by the first TWIN BEAM COLOR Mk3 Lasers (master) in the chain.
 Connect the DMX input of the laser to the DMX output of the previous laser in the chain.
 Press the FUNC-button until the display shows "SLA"
 Press the ENTER-button to confirm your choice.
You can connect several TWIN BEAM COLOR Mk3 Lasers together. Please put the first unit of the chain
in "Music or automatic mode" and all other units in "Slave mode" (display shows "SLA" to make them all
work in perfect sync!
4) DMX512 MODE:
The laser can be controlled by any standard DMX-controller in 2 different DMX-modes:
 1 CHANNEL MODE: for extremely easy setup and use! (display shows "1Ch")
 9 CHANNEL MODE: for full control of all possibilities. (display shows "9Ch")
 Connect the DMX input of the laser to the DMX output of the previous unit in the chain or directly to the
DMX-output of your controller.
 Press the FUNC-button until the display shows: "1Ch" or "9Ch".
 Press the UP/DOWN buttons to select the desired DMX-mode. (1Ch or 9Ch)
 Press the ENTER-button to confirm your choice.
 Press the FUNC-button: the 3 digit number on the display starts blinking.
 Select the desired DMX-address
 Press the ENTER-button to confirm your choice.
Note: the display blinks when the unit is in DMX-mode and no DMX-signal is detected.
Some more information on DMX512:
The DMX-protocol is a widely used high speed signal to control intelligent light equipment. You need to
"daisy chain" your DMX controller and all the connected light effects with a good quality XLR M/F balanced
cable. To prevent strange behavior of the light effects, due to interferences, you must
use a 90Ω to 120Ω terminator at the end of the chain. Never use Y-splitter cables,
this simply won't work!
Each effect in the chain needs to have its proper starting address so it knows which
commands from the controller it has to decode.
JB SYSTEMS
®
6/57 TWIN BEAM COLOR Mk3 Laser
USER MANUAL