Nemox gelato 10K Instrucciones Para El Uso página 7

the mixture varies according to the recipe
and paddle rotation speed. To a lower
number of revolutions corresponds a
higher density. (less air incorporated into
the ice cream). To a greater number of
revolutions corresponds a smaller density
of the product (more air incorporated into
the ice cream). We recommend you use
low speeds when preparing classic Italian
gelato, Granita and sorbet, and high
speeds when preparing semi-soft Italian
gelato.
•When the preparation has reached the
desired consistency, turn off the cooling
system by rotating the knob (1) and stop
the paddle by rotating the knob (2). To
easily remove the preparation from the
pot, remove the mixing paddle (5) by
loosening the appropriate locking ring (4).
•Use the spatula (12) to remove the ice
cream. Avoid any metal tool.
•Turn off the machine by operating the
main switch (10).
TIPS
• U s i n g i n g r e d i e n t s a t r e f r i g e r a t o r
temperature will reduce the processing
time. Furthermore, it is possible to reduce
the temperature of the ingredients if hot
with the appropriate fast cooling program.
•Be careful not to insert ingredients that are
too cold or nearly froze, as whipping may
have a poor quality.
•For a correct volume increase during
m i x i n g , u s e m a x i m u m
ingredients for the preparation of ice
cream and sorbet.
•For the preparation of Granita, the
maximum amount of ingredients is 2Kg
with the paddle supplied with the
machine.
It can process up to 2.7kg of Granita using
the special Granita paddle that can be
purchased separately.
CLEANING THE POT
GELATO 10K is designed to facilitate the
English
pot cleaning. Proceed as follows:
•Turn off the cooling system, remove the
paddle and pour at least 2 litres of hot
water and a low-foaming detergent into
the pot.
•Wash the pot with a sponge. Do not use
sharp utensils inside the pot.
•Place an empty container of at least 3
litres under the drain (7).
•Remove the plug (9). The water in the pot
begins to flow into the container below.
•Repeat the operation using hot, clean
water and rinse thoroughly.
•When the pot is empty, clean the
discharge pipe using the cleaner (11)
previously cleaned.
•Clean the plug (9). Reposition the plug (9)
until the pot discharge is fully closed.
•If necessary, repeat the cycle until the pot
is completely cleaned. Proceed with the
sanitization (see the SANITIZATION
chapter) in order to avoid any bacteria
growth.
•Dry with a disposable paper towel.
MAINTENANCE AND CLEANING OF THE
MACHINE
•Before cleaning the machine, make sure
that it is turned off (main switch (10) to
OFF) and unplugged from the power
plug.
•Remove paddle inserts.
•Remove the steel pin and remove the
transparent lid (3) from the machine.
2 . 2 k g o f •The paddle (5), the paddle inserts (18),
(19) and (20), the transparent lid (3), the
transparent lid cap (3a), the plug (9) and
ahe locking ring (4) can be washed in the
dishwasher or in hot water with suitable
detergent.
•If the paddle inserts are damaged or worn
out, they must be replaced to prevent
mixing ingredients less effectively.
•Clean the body of the machine and the
non-removable parts with the specific
product given in SANITIZING chapter.
IMPORTANT: do not wash the machine
7