Dmx Addressing - Ampro TechShow ION 230B Manual De Usuario

Select Chase②
Edit Chase②
Edit Scenes②
Scenes Record
5. DMX connection and DMX protocol

5.1 DMX addressing:

5.1.1 The device is controlled by universal DMX 512 proto-
col, DMX address is the start channel used to receive instruc-
tions from the external controller. For independent control,
each fixture must be assigned its unique address control
channels. For example, this device has four channel modes:
16/19/12/14, if we set the mode at standard 16 channels
mode, and there are several models need to be independent-
ly controlled, we just simply address first fixture at 1, and sec-
ond fixture at 17, third one at 33, etc.
If the devices have the same address, they will behave syn-
chronically.
DMX addressing is limited, don't set the address so high that
without enough control channels for the fixtures.
Display is flashing when no DMX signal is received.
ION 230B
ENGLISH VERSION
DMX Re-
ceive
Slave Re-
Play①
ceive
Sequence
Music
Chase Part 1
Chase Part 2
Chase Part 3
Chase 1
:
Chase 8
Edit Scene
001
~ Edit Scene
250
Slave Receive 1,2,3
Master / Alone
Master / Alone
Chase 1 ~ 8 Chase 1
Chase 1 ~ 8 Chase 2
Chase 1 ~ 8 Chase 3
Chase Test
Step 01 0
Step 64 0
Pan,Tilt,...... 0
--Fade Time-- 0
--Secne Time-- 0
DMX Input
ScXX=>ScXX
5.1.2 This device is equipped with 3-pins DMX in and out
sockets only. Pin 1 = GND | Pin 2 = Signal (-) | Pin 3 = Signal (+)
5.1.3 The termination is prepared by soldering a 120Ω resis-
tor between pins 2 and 3.
DMX Receive
Choose slave position
Run Sequence
Music mode
Select and run auto
program
Test
Beginning scene
Ending scene
Input manual scene
Modify manually fading
time
Modify manually scene
time
Input scene from exteri-
or controller
Auto Input scenes
p. 12