Dmx-512 Connection; Dmx Address Setting - Ampro TECSHOW MUSHROOM 40W Manual De Usuario

DMX-512 connection

Connect the provided XLR cable to the male 3-pin
XLR output of your controller and the other side to
the female 3-pin XLR input of the light.You can chain
multiple lights together through serial linking
The cable needed should be two core, screened
cable with XLR input and output connectors. Please
refer to the diagram below.

DMX address setting

Each fixture must have a specific starting address.
When receiving signal transmission, fixture will
receive channel control signals from DMX controller
through this starting address.
According to different requirements or easy to
use, the user can set many fixtures to the same
address, also can set up a separately address for
every device. If more than one fixtures have the
same address, all of them receive the same DMX
channel signal from DMX controller. All connected
120 0hms
Address 13
DMX Output
XLR Mounting socket
Address 7
DMX Input
XLR Mounting socket
1. Ground
2. Signal (-)
3. Signal (+)
fixtures are jointly controlled, DMX controller can't
control a device separately. If each device has a
different address, each device will be separate and
accept separate DMX512 control signal through the
separate DMX address, so that more convenient to
control one device separately. this method must be
based on channel quantity of device to determine a
starting address.
This device has 6 channels, so the first device start-
ing address set 1, the second is 7(1+6), the third is
13(1+12) and so on.
Address 1
DHX 512
DHX 512 - Controller
| Tecshow Mushroom 40W
English version
P. 9