Using A Console Connection - Juniper Networks NETSCREEN-5GT ADSL Guía De Usuario

Using a Console Connection

Note: For the console connection, use a serial cable with a male RJ-45 connector on one
end and female DB-9 connector on the other end. See
connector pinouts for the serial cable.
To establish a console connection:
1. Plug the female DB-9 end of the serial cable into the serial port of your
computer. (Be sure that the DB-9 connector is seated properly in the port.)
2. Plug the male RJ-45 end of the serial cable into the Console port of the
NetScreen-5GT ADSL device. (Be sure that the RJ-45 connector is seated
properly in the port.)
3. Launch a serial terminal emulation program. (A commonly-used terminal
program is Hilgreave HyperTerminal.) The required settings to launch a console
session with your NetScreen-5GT ADSL device are as follows:
–
–
–
–
–
4. If you have not yet changed the default user name and password, enter
netscreen in both the login and password prompts. (Use lowercase letters
only. The login and password fields are both case sensitive.)
NetScreen-5GT ADSL
Baud Rate: 9600
Parity: No
Data Bits: 8
Stop Bit: 1
Flow Control: None
Accessing the Device
Appendix A, Specifications for the
13