Self-Adjusting Brush Head; How To Replace The Vacuum Belt; Circuit Breaker Protection - Tennant V-LWU-13 Manual De Operación Y Partes

Your upright vacuum cleaner is designed with a Self-Adjusting Brush Head. No manual adjustments are required. The
height of the brush head is instantly adjusted to carpet pile height. This self-adjusting feature allows the brush head to
float evenly over all carpet pile surfaces.
NOTE: To ensure maximum cleaning efficiency, the belt should be checked regularly to be sure it is in good
condition. Replace the belt if it is stretched, cracked, or if excessive slipping is occurring.
1. Turn the vacuum cleaner over and remove the bottom plate. (Fig. 18)
2. Remove the brush and the belt from the brush pulley and the motor drive shaft. (Figs. 19 - 20)
3. Slide the new belt on the right side of the motor drive shaft to get it looped around the motor drive shaft.
Then loop the belt onto the brush. (Fig. 21)
4. Reinstall the brush back into the housing. Turn the brush by hand, making sure the belt is not
twisted and all rotating parts move smoothly.
5. Reinstall the bottom plate.
(Fig. 18)
Your new vacuum cleaner is protected by a circuit breaker to prevent motor damage due to airflow or brush obstruction.
Should your vacuum cleaner experience an obstruction, the circuit breaker will trip and safely turn off the vacuum cleaner.
To reset circuit breaker
1. Press the on/off switch to the off position "O" and unplug the vacuum cleaner cord.
2. Check brush and remove any entangled objects. Remove bottom plate to access obstruction if necessary.
3. Check for airflow obstruction and remove obstruction (full bag, clog in brush head air intake, clog in handle, etc.).
4. After removing obstruction reset the circuit breaker by pushing the reset button and resume operation (Fig. 22).
NOTICE: Do not repeatedly reset circuit breaker button without removing obstruction, motor failure may result and void warranty.
If vacuum cleaner fails to turn on, contact a Tennant or Nobles Authorized Service Center or Distributor.

SELF-ADJUSTING BRUSH HEAD

HOW TO REPLACE THE VACUUM BELT

CAUTION: Turn off and unplug the vacuum
cleaner before performing any of these steps.
(Fig. 19)

CIRCUIT BREAKER PROTECTION

CAUTION: Turn off and unplug the vacuum
cleaner before performing any of these steps.
(Fig. 20)
(Fig. 22)
8
(Fig. 21)