Problems And Solutions - SMA LIGHT 360 Manual De Usuario

HOW TO PERFORM A PATCH TEST
Because the skin tone varies from area to another, you should perform a patch test to each
body area to be treated. First check your skin tone comparing it with the skin color chart on the
instruction manual and packaging.
Identify a small area to be treated.
Shave the area to be treated.
After having set to the lowest level, apply the handpiece to the area and emit the first pulse.
If you do not feel any kind of discomfort, increase the energy to the next level, move the
handpiece to the adjacent part of skin and emit a new flash.
Increase the energy level on every part of the next skin until reaching the highest level (but it must
remain bearable depending on skin type). During treatment it is possible (and normal) to feel a
warm sensation on the skin. If there is a feeling of discomfort, it means that the highest energy
level endured the previous one.
After 24 hours check the area: the persistence of redness indicates that the skin tolerated
the highest energy level on the previous one. Although it is extremely rare, if hypersensitivity
persists for more than 24 hours, it is advisable to consult a physician.
CAUTION: The energy directly delivered affects the result, but because of the principle
treatment, you should not exceed the maximum threshold that your skin is able to tolerate. This
threshold is normally high for light skins and low for dark skins, because the presence of melanin
darkens the skin, increases heat production. Do not exceed the highest threshold that your skin
can tolerate without any kind of discomfort.
MAINTANANCE
CLEANING AND CONSERVATION
It is recommended that you clean the Flash window after each epilation session:
Switch off the appliance by holding the ignition button down (9) and disconnect the Power plug
(6)
Gently wipe the flash window of the device (11) with a clean dry cloth. For proper cleaning of
the flash area, it is highly recommended to use Kera Flux detergent at luce-pulsata.net
Store the appliance in a cool dry place, away from heat and water sources.
When the light is empty, the counter reaches zero.
17
NOTE:
If large stains appear inside the treatment surface (11) or if the latter is cracked or broken, do not
use the appliance and contact the D Light Service center. After replacing the lamp, always set the
energy level to lower than the one used normally. In the next session, increase the energy level
again only if the there is no abnormal discomfort during or after treatment.
Never immerse the appliance or any of its parts in water!

PROBLEMS AND SOLUTIONS

PROBLEM
The appliance does not start
The contact sensor does not detect the skin
The appliance does not emit pulses
The device buttons are not pressure sensitive Contact our customer support
The status displays the message "error"
CONTROL/SOLUTION
Connect to a better power socket
Contact our customer support
Replace the lamp
Contact our customer support
Check if the display does not blink when in
contact with the skin
Replace the lamp
Contact our customer support
Disconnect and reinsert the light
Replace the lamp
Contact our customer support
18