Proline PGH4FGL-FR Manual De Instrucciones página 23

Before making the cut out in the worktop ensure that the edges of the hob that are to
be near either a side or rear wall have a minimum distance of
edge of the hob and the wall.
The minimum distance combustible material can be fitted above the hob is 400mm. If
it is fitted below 400mm a space of 50mm must be allowed from the edge of the hob.
The minimum distance combustible material can be fitted directly above the hob is
700mm.
A minimum distance of
any adjacent cabinet or wall.
When the hob is first installed
Once the hob has been installed, it is important to remove any protective materials
which were put on in the factory.
On the end of the shaft, which includes the GJ 1/2" threaded elbow, adjustment is fixed
so that the washer is fitted between the components as shown in the diagram. Screw
the parts together without using excessive force.
A. End of shaft
B. Washer
C. Elbow
Important:
When installing the hob above a built in oven, the oven should be placed on two
wooden strips; in the case of a joining cabinet surface, leave a space of at least
45 x 560mm at the back (see diagrams below).
200mm must be left between the side edges of the hob and
It is important to install the elbow correctly,
with the shoulder on the end of the thread, fitted to
the hob connection pipe.
Failure to ensure the correct assembly will cause
leakage of gas.
8
60mm between the