Commissioning - SCHOLTES LTE S3 XL60HZ Instrucciones De Uso

Do not use extension cords, adaptors or shunt
connections in order to avoid the possibility of
overheating or burning, with consequent fire hazard.
In the event of damage to the supply cord, have it
replaced by the manufacturer or an authorized technical
service centre in order to avoid any risk.

5.3 Commissioning

5.3.1 Installation procedure (all models)
Clean the underneath of the worktop lying over the
dishwasher door (see fig.5-15) and apply the steam
guard, as shown in fig. 5-16 (see fig. 5-16 if the adhesive
guard is applied; see fig. 5-17 if the steel guard is
applied). This guard protects the worktop from steam
and condensation when the door of the dishwasher is
opened at the end of the washing cycle.
Fig. 5-15
Fig. 5-16
Fig. 5-17
Push the dishwasher into position, taking care not to twist
or crush the power cord or hoses (see fig. 5-18).
Two people wearing safety gloves are needed to push
the dishwasher into place.
Fig. 5-18
5.3.2 Procedure for mounting the door
panel (models LTE)
Mount the door panel.
Place the template on the inner surface of the panel,
centering it along the upper side and matching up the
reference locators (ref. A fig. 5-19); mark the position of
the door hooks with a pencil (see fig. 5-19). Remove the
template and use a drill with a suitable bit to make holes
at the points marked on the panel.
Fig. 5-19
EN
13