Troubleshooting - SCHOLTES LTE S3 XL60HZ Instrucciones De Uso

10 TROUBLESHOOTING

EN
The dishwasher can signal a number of malfunctions by turning on various indicator lights, as described below (see
following table):
E1
E2
E3
E4
E5
E6
E7
E8
E9
Light off
If an alarm situation occurs, the dishwasher interrupts the current program and signals the fault.
•
Alarms E1, E2, E3, E4, E8, E9 immediately terminate the current program.
•
Alarms E5, E6 interrupt the current program and, after the problem has been eliminated, resume the cycle.
•
Alarm E7 is displayed at the end of the cycle which, however, is completed given that it does not jeopardize
dishwasher operation.
To "reset" an alarm:
•
open or close the door, or switch the appliance on and back off again. At this point, the dishwasher can be
programmed again.
If the fault persists, contact the Authorized Technical Assistance Service.
28
FAULT DESCRIPTION
Acquastop failure
The anti-flooding system has tripped. Activates in case of water leaks. Contact the technical
assistance service.
Safety level
The system limiting the water level in the dishwasher has tripped. Interrupt the current program
and switch off the dishwasher. Switch it back on again, program a new cycle and press start. If
the problem persists, contact the technical assistance service.
Water heating malfunction
The water is not heated or is incorrectly heated. Repeat the washing program; if the problem
persists, contact the technical assistance service.
Water temperature monitoring malfunction
Interrupt the current program and switch off the dishwasher. Switch it back on again, program a
new cycle and press start. If the problem persists, contact the technical assistance service.
Water intake malfunction
The appliance does not take in water or does so incorrectly. Make sure the water connections
are correct, that the water supply tap is open and that the filter is not clogged. If the problem
persists, contact the technical assistance service.
Water pump-out malfunction
The appliance does not pump out the water or does so incorrectly. Make sure the drain hose is
not kinked or crushed and that the siphon and filters are not clogged. If the problem persists,
contact the technical assistance service.
Turbine flow-regulator malfunction
The appliance is unable to precisely measure the quantity of incoming water. Interrupt the
current program and switch off the dishwasher. Switch it back on again, program a new cycle
and press start. If the problem persists, contact the technical assistance service.
Alternate washing system malfunction
Interrupt the current program and switch off the dishwasher. Switch it back on again, program a
new cycle and press start. If the problem persists, contact the technical assistance service.
Water intake system malfunction
Contact the technical assistance service.
Light on Light flashing