Publicidad
Idiomas disponibles
Idiomas disponibles
SYSTEM CHARACTERISTICS
The cruise control should only be used
while mowing or transporting on relatively
smooth, straight surfaces. Other conditions
suchas trimming atslow speeds may cause
the cruise control to disengage. Do not use
the cruise control on slopes, rough terrian
or while trimmimg or turning.
• With forward drive pedal depressed to
desired speed, pull cruise control lever
(J) up and hold while lifting your foot off
the pedal, then release the lever.
Todisengagethe cruisecontrol,depressthe
brake pedal or tap on forward drive pedal.
TO ADJUST
GAUGE
WHEELS
Gauge
wheels
are properly
adjusted
when
they are slightly
off the ground
when
mower
is at the desired
cutting
height
in operating
position.
Gauge
wheels
then keep the deck
in proper
position
to help prevent
scalping
in most terrain
conditions.
NOTE:
Adjust
gauge
wheels
with tractor
on
a flat level surface.
1. Adjust
mower
to desired
cutting
height
(See "TO ADJUST
MOWER
CUTTING
HEIGHT"
in this section
of manual).
2.
With mower
in desired
height of cut posi-
tion, gauge wheels
should
be assembled
so they are slightly
off the ground.
Install
gauge wheel
in appropriate
hole. Tighten
securely.
3.
Repeat
for all, installing
gauge
wheel
in
same adjustment
hole.
TO ADJUST
MOWER
CUTTING
HEIGHT
The position
of the attachment
lift lever
(A)
determines
the cutting
height.
• Put attachment
lift lever
in desired
cut-
ting height
slot.
• Slide
pointer
tab
(T) to desired
cutting
height as a reminder
for next time you mow.
The cutting
height
range is approximately
1 "to 4". The heights
are measured
from the
ground to the bladetipwith
the engine not run-
ning. These heights are approximate
and may
vary depending
upon soil conditions,
height
of grass
and types
of grass
being
mowed.
• The average
lawn should
be cutto approxi-
mately 2-1/2 inches during the cool season
and to over
3 inches
during
hot months.
For healthier
and
better
looking
lawns,
mow
often
and
after
moderate
growth.
• For best cutting
performance,
grass over
6 inches
in height should
be mowed twice.
Make the first cut relatively
high; the sec-
ond to desired
height.
TO OPERATE
MOWER
Your tractor
is equipped
with an operator
presence sensing switch. Any attempt by the
operator to leave the seat with the engine
running and the attachment
clutch engaged
will shut off the engine. You must remain
fully and centrally positioned
in the seat to
prevent the engine from hesitating or cutting
offwhen operating your equipment on rough,
rolling terrain or hills.
1. Select desired height of cut with attach-
ment lift lever.
2. Start mower blades by engaging attach-
ment clutch control.
TO STOP MOWER BLADES
-
disengage
attachment
clutch control.
,_CAUTION:
Do not operate the mower
without either the entire grass catcher, on
mowers so equipped, or the deflector shield
(S) in place.
15
Publicidad
