Publicidad
Idiomas disponibles
Idiomas disponibles
TO LEVEL MOWER
Make sure tires are properly inflated to the
PSIshown on tires. Iftires are over or under
inflated,itmay affectthe appearanceof your
lawn and lead you to think the mower is not
adjusted properly.
VISUAL
SIDE-TO-SIDE
ADJUSTMENT
1. With all tires properly inflated and if your
lawn appears
unevenly
cut, determine
which side of mower is cutting lower.
NOTE: As desired, you can raise the low
side of mower or lower the high side.
2. Go to side of mower you wish to adjust.
3. Witha3/4"oradjustablewrench,turnliftlink
adjustment nut (A) to the left to lower the
mower, or, to the right to raise the mower.
NOTE: Each full turn of adjustment
nut will
change mower height about 3/16".
Turn nut right
_\
Turn nut left
to raise mo_,._
\\\\\\
toj_ower mower
02948
4. Test your adjustment
by mowing some
uncut grass and visually checking
the
appearance.
Readjust, if necessary, until
you are satisfied with the results.
PRECISION
SIDE-TO-SIDE
ADJUSTMENT
1.
With all tires properly
inflated,
park tractor
on level ground
or driveway.
CAUTION:
Blades
are sharp.
Protect
your
hands
with gloves
and/or
wrap
blade
with heavy
cloth.
2.
Raise mower
to its highest
position.
3.
At both sides of mower,
position
blade at
side and measure
the distance
(A) from
bottom
edge of blade to the ground.
The
distance
should bethesameon
both sides.
5.
Recheck
measuraments,
adjust if neces-
sary until both sides
are equal.
FRONT-TO-BACK
ADJUSTMENT
IMPORTANT:
Deck must be level side-
to-side.
To obtain the best cutting results, the mower
blades should be adjusted so the front tip is
1/8" to 1/2" lower than the rear tip when the
mower is in its highest position.
CAUTION:
Blades are sharp.
Protect
your hands with gloves and/or wrap blade
with heavy cloth.
• Raise mower to highest position.
• Position any blade so the tip is pointing
straight forward. Measure distance (B) to
the ground at front and rear tip of the blade.
B
B
• If front tip of blade is not 1/8" to 1/2" lower
than the rear tip, go to the front of tractor.
• With an 11/16"
or adjustable
wrench,
loosen jam nut A several turns to clear
adjustment
nut B.
• With a 3/4" or adjustablewrench,
turn front
link adjustment nut (B) clockwise (Itighten)
to raise the front of mower, or, counterclock-
wise (loosen) to lower the front mower.
Tighten adjust nut
B to raise mower
Loosen adiust nut
B to lower mower
4.
If adjustment
is necessary,
see steps
2
and 3 in Visual
Adjustment
instructions
above.
Loosen jam nut A first
NOTE:
Each full turn of the adjustment
nut
will change
mower
height
about
1/8".
•
Recheck
measurements,
adjust
if neces-
sary until front tip of blade
is 1/8" to 1/2"
lower
than the rear tip.
25
Publicidad
