Configuration For Rpt - Resol KM2 Manual De Instrucciones

5.1 Configuration for RPT
In order to use RPT, the VBus.net access over the local network has to be enabled,
see chap. 7.18 on page 36.
With a VBus.net account you can easily use RPT in order to parameterise the
controller:
Î In the VBus.net menu My Devices, click on Edit.
Î On the General settings page, tick the option Allow parameterization
using the via address and the RESOL Parameterization Tool (RPT).
Î Enter the Via tag from the VBus.net menu item General settings into the RPT
field URL/IP.
Î Enter the password into the Password field.
Î Click Connect.
5.1.1 Direct connection via WLAN (service access)
Connecting devices directly to the KM2 over WLAN
Note
Before using the WLAN, make sure that the WLAN country setting is
correct, see chap. 7.15 on page 35.
The WLAN allows the installer to directly connect with the KM2 without having
to access the LAN network of the customer. All access data required can be found
on the back of the housing.
In order to connect computers and other devices such as smartphones to the KM2
Communication module via WLAN, proceed as follows:
Î If the WLAN LED is not illuminated, briefly press the button.
WLAN will be activated.
Î Select the WLAN network of the KM2 on your smartphone and enter the
network name (SSID).
The network name can be read in the Configuration / Network menu under
Access point settings. The default SSID name is KM2-{12-digit serial number}.
Î Click Connect.
Î Enter the WLAN code of the KM2.
This code can be read from the label on the back side of the housing (WLAN-AP).
Î Establish the connection.
After the WLAN connection with the KM2 has been established, the Web interface
can be reached with an Internet browser under the IP address http://192.168.240.1
or the controller can be parameterised over RPT. If you access the website in its
encrypted version (https), a security enquiry can appear. You can either ignore this
warning or access the unencrypted version (http).
DeviceDiscovery will not be necessary.
Web-Inter. admin XxXxXxXxX
WLAN-AP - xxxxxxxx
SSH root xXxXXXX
5.1.2 Connection in the home network
The KM2 Communication module can be connected to the home network via
LAN, in order to access the RESOL controller with the RESOL RPT Parameterisa-
tion Tool or to configure the Communication module over the Web interface. For
further information, see:
chap. 3.3 (W)LAN connection on page 26
chap. 6 Finding the KM2 Communication module in the network on page 31
chap. 7.12 Network configuration on page 34
chap. 7.18 Configuring the remote access on page 36
29