Fuel And Oil; Switch On - Truper LAGAS-2800 Manual De Instrucciones

Hidrolavadora a gasolina
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Oil Supply
• Set the Pressure Washer on a flat and leveled surface.
• Close the fuel valve (A).
• Turn and remove the oil cap from the tool (B).
• Pour all the contents into the 16 oz oil bottle included. Into
the oil deposit. Use a Funnel.
• Set the cap back into the deposit mouth and remove it to
check the oil level in the cap measuring road.
• Once the tank has the right oil level indicated in the rod
tighten the cap to prevent leaks.
Fuel Supply
• Set the Pressure Washer on a flat and leveled surface.
• Mix the fuel stabilizer with the gasoline following the
stabilizer manufacturer instruction.
• Clean and dry the area around the fuel cap.
• Remove the fuel cap.
• Using a funnel fill slowly the fuel tank up to an
approximate level of 1,5" below the upper part of the
tank's neck to allow fuel to expand.
• Clean any fuel spills.
• Cover the tank rotating the cap until hearing a click.
• Clean any fuel spilled before starting up.
CAUTION
Before starting up the Pressure Washer it is essential to follow the next points. Otherwise the Pressure
Washer can get damaged and the warranty will be made void:
• All the hoses shall be connected totally unrolled and with no twists.
• The water supply shall be connected and fully open.
• Gasoline and oil levels shall be the correct ones.
• The system shall be purged off any air bubbles (see page 7).
Starting Up
• Open the fuel valve (C).
• Move the choke lever to the "Start" position (D).
• Turn on the switch (E).
• Pull the starter rope handle (F) until the motor starts,
but, no more than 6 times. When you pull the starter rope
handle let it go back softly. Never allow it to snap back.
• Let the motor running 5 seconds and then move the choke
lever into the "Gear" position (G).
CAUTION
• If the motor is not starting after pulling the
starter rope, press high pressure gun to release pressure from
the water before trying to start the motor one more time.
Setting Off
• Turn off the switch.
• Press the trigger in the high-pressure gun to release pressure.
8
ENGLISH

Fuel and Oil

A

Switch On

D
C
F
16 oz
B
E
G

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Lagas-33001290812909

Tabla de contenido