Start Up; Spray Nozzle Selection - Truper LAGAS-2800 Manual De Instrucciones

Start Up

High-pressure Gun Operation
• To get water coming out through the metal spear keep
the gun trigger pressed.
• To stop the water jets release the trigger.
• To prevent unexpectedly starting up raise the trigger lock
until it gets blocked in the slot (H).
• To release the lock push it back to its original position (I).

Spray Nozzle Selection

• The Pressure Washer has different spraying nozzles with different flow opening depending on the type of the job:
Nozzle
Red
Yellow
(Only LAGAS-3300)
Green
White
Black
Spray Nozzle Assembly
CAUTION • Before assembling or removing a
nozzle in the metal spear turn off the Pressure Washer,
close the water supply, press the trigger to release the
pressure and lift the gun trigger lock. Failure to comply
with one of these points exposes the operator to severe
injury.
CAUTION • When assembling and removing
nozzles prevent from pointing the spraying pipe towards
your face. The nozzles fast connection system could
accidentally throw it and injure the operator.
• To assemble the nozzles push the fast connection ring
(J).
• Set the nozzle in the spraying pipe.
• Pull the fast connection ring to secure the nozzle in
place (K).
• To disassemble the nozzle, push the fast connection ring
and pull the nozzle to release it.
Flow Abrasion
0°
15°
25°
40°
soap
H
Cement, Brick, Exteriors, Hedges,
Masonry Patios, Terraces
Recommended Nozzle
J
K
I
Boats, RV's,
Gardening Gear
Use with Caution
ENGLISH
9