How To Use - Koshin Mister AUTO HS-C Serie Manual De Instrucciones

EN
Assemble nozzle.
Nozzle body
Model with extendable pipe
Use and connect extension pipe as lower figure,
if necessary.
Nozzle body Extendable pipe
To combine
To detach
Caution
Make sure that packing is preset on connection part.
Tighten up well so no leakage.
Pull pump out.
1. Rotate tank cap to pull pump out after lock the claw.
Claw
Tighten
Loosen
Tank cap
2. Rotate handle to
remove pump.

How to Use

Pour chemical into tank.
Dissolve chemical sufficiently in a separate container
Nozzle To
before pouring into tank.
combine
Completely dissolve.
Any chemical added must be completely dissolved.
Packing To detach
Nozzle
To
combine
*Container is not included in set.
To
detach
Be sure that no previously used chemical has
been left in tank. If so, chemical reaction may
occur generating harmful gas.
Do not exceed specified quantity. This would
shorten spraying duration. (Specified quantity : 5L
tank: 5th scale, 7L tank: 7th scale)
Water
Pull out
Tighten up well tank cap after pouring dissolve
chemical into tank. If pump not closed tightly enough
when applying pressure, may cause air leakage.
Caution
Caution
Chemical (cc)
(L)
×500 ×1000 ×2000
1 2 1
4 8 4
5 10 5
7 14 7
3cc 2cc 1cc
Scale unit of syringe: cc
(cc = g = ml)
Caution
- 2-
Restore pump to original position before pressurizing.
Do not pressurize when nozzle is in nozzle stand.
This may cause injury.
Make sure that nozzle lever is not set for spraying
before applying pressure to prevent erroneous
function.
1. Attach pump to tank after
fasten cylinder completely
while holding tank cap.
0.5
3. Stop pressurizing when
2 safety valve pops air.
This means appropriate
2.5
pressure has been obtained
3.5
for spraying. (Check " Red
marking" of safety valve.)
Safety Valve
Set for preventing breakage due to overpressure,
this automatically lets excess pressure out when
appropriate pressure is reached.
4. Lock handle after applying pressure.
Warning
Caution
Tighten
Pressurizing
2. Release lock, then move
handle up and down to
pressure inside of tank.
Red
marking