Outdoor Camera/Relay 2 (Op20) Connector Description; Relay Functions And Configurations; Jumper Configuration (Jp1 And Jp2); Dip-Switch Configuration - Urmet 1723/71 Manual De Instalación

7.4

OUTDOOR CAMERA/RELAY 2 (OP20) CONNECTOR DESCRIPTION

The outdoor camera ref. 1092/250A can be connected to the Master video door phone using the wire (B7)
provided.
Wire n. Wire colour
1 Blue
2 Blue
3 Red
4 Brown
5 Yellow
6 Black
7.5

RELAY FUNCTIONS AND CONFIGURATIONS

The video door phone is provided with two programmable relays, as shown in the following table:
Relays
Supplementary ringer
1 Home Automation button 1
Siren alarm
Home Automation button 2
2 Siren alarm
Thermostat output
7.6

JUMPER CONFIGURATION (JP1 and JP2)

There are two jumpers on the video door phone:
• JP1: this is used to insert the line termination. The line termination must be activated on the video door phone
connected to the end of a line which is not resumed with another segment from the LINE OUT terminals.
Terminal insert (default)
Terminal not inserted
• JP2: this is used to power the video door phone from the Bus line or via a local transformer ref. 1723/22.
Bus light power supply (default)
Power from local transformer
7.7

DIP-SWITCH CONFIGURATION

The video door phone has 8 dip-switches on the back of the device.
Dip-switches 5, 7 and 8 are not used.
34
Description
Staircase lights (relay output 2 – OP20)
Staircase lights (relay output 2 – OP20)
Camera power positive
Video balun negative output signal
Video balun positive output signal
Camera power negative
Possible function
JP1
JP2
Pin name on connector
RELAY SPARE
RELAY SPARE
CCTV POWER+
CCTV VIDEO-
CCTV VIDEO+
CCTV POWER-
Default Riference
✔
OP5
✔
OP20
DS1723-001