Power Supply Interrupted During Printing - Hiti P530D Manual De Instrucciones

＊ Attention: If the paper is used without cutting off the folded or printer section, paper
jam occurs every time or the ribbon may snap during printing. Always cut
off the creased or printed section of the paper.
＊ Attention: Cut off the paper straight and at right angles to the roll paper direction
＊ Attention: If paper jam occurs frequently, a defect in the mechanical section is assumed.
Consult with HiTi dealers or service center.

◎ Power Supply Interrupted During Printing

In the course of printing, in case of unexpected power interruption, please must always repower on
the printer to reset. Leaving this situation for a long time, the shape of Platen can be warped. In order
to avoid this situation, please follow the instruction below.
1. Switch off the power of the printer
2. Always await 3 or more seconds for power on and off.
3. Paper jam is displayed on the LCD of the operation panel, open the front cover or rear jam
door and take the necessary actions according to the instructions of "Paper Jam" solution.
When the ribbon is snapped
7.6
Stick the broken part of ribbon with a tape.
7.7
Turn the ribbon on the rewinding side and
rewind the tapped section completely and
tightly.
22