Configuration - Ferroli RIMINI DP Instrucciones Para La Instalación Y El Uso

RIMINI DP
FIL PILOTE:

CONFIGURATION:

The radiator heating will be indicated on the TFT screen in two ways, in any heating mode:
1. With the backlight Evanescent function. This function can be manually activated or
deactivated by the user.
To do this, touch the sun key
The evanescent function will be switched on and off, appearing on the display:
When activated, the display indicates the heating of the radiator with the light, changing
its luminosity from the minimum to the maximum and vice versa continuously, in a cycle
of 6 seconds. By default it is deactivated.
A73021552
See section 5.5 "Edit day, time and program" to modify the
program used in this mode.
In this "fil pilote" mode, the radiator will automatically follow
the orders from the pilot wire control unit. Normally found in
France (*).
(*) If there is no pilot wire regulation system the radiator
works in comfort mode.
The configuration screen is at the end of the modes sequence, before entering
the initial comfort mode.
You can configure 4 parameters; the active parameter is flashing:
1 - Brightness level at rest, from 0 to maximum (100%)
2 - Maximum brightness time, from 1 s to 240 s
3 - Open Window function ON or OFF
4 - Adaptive start control function ON or OFF
To modify a parameter, use the
to the next, touch the OK key. The system exits this mode by touching the
mode key at any time, by waiting 30 seconds without touching any key or by
touching the OK key on the last parameter.
MODE
MODE
and keys. To move from one parameter
.
EN
57