Pride FULL-SIZE Serie Manual Del Propietário página 25

I I I . B AT T E R I E S A N D C H A R G I N G
7. Connect the red battery cable to the positive (+) battery terminal on each battery.
8. Connect the black battery cable to the negative (-) battery terminal on each battery.
9. Reposition the terminal boots over the battery terminals.
10. Reconnect the battery tie-down straps.
11. Reinstall the battery shroud, the rear shroud, and the seat.
NOTE: If you encounter a damaged or cracked battery, immediately enclose it in a plastic bag. Contact your
local waste disposal agency or your authorized Provider for instructions on disposal and battery recycling,
which is our recommended course of action.
1. Secure the batteries in the battery wells by routing the provided battery straps through the battery well slots
as shown.
2. Ensure the short strap runs over the top of the long strap.
NOTE: Before securing both straps, ensure the D-ring is positioned as shown here. The D-ring should be
positioned within 1 inch (2.54 cm) of, but never touch, the battery well.
3. Any excess strapping should be placed facing the back, or next to the seat post, of the scooter.
WARNING! The battery straps should never be positioned under the battery.
Figure 16. Battery Securement for Models 614 and 714
Full-size Scooter Series
Battery Securement and Strap Routing
IDENTIFICATION KEY
1. REUSABLE FASTENER
2. SHORT STRAP
3. LONG STRAP
4. D-RING
2
3
7
8
5. FRONT SLOT
6. SIDE SLOT
7. REAR SLOT
8. BATTERY SPACERS
1
6
5
4
25