Maintenance - Black and Decker GH710 Manual Del Usuario

just reach the blade (figure M).
REWINDING SPOOL IF LINE UNRAVELS
(USE ONLY .065 IN. ROUND DIAMETER
NOTE: Hand wound spools are likely to
LINE) (FIGURES O & P)
become tangled more frequently than Black
& Decker factory wound spools. For best
results, factory wound spools are
recommended.
To rewind spools, follow the steps below:
• Unplug the tool.
• Remove the empty spool from the tool
as described in "REPLACING THE SPOOL".
• First wind new line onto the uppermost part of
the spool.
• Feed 3/4 inch (19mm) of
cutting line into one of the line
anchoring slots.
• Wind the cutting line onto
the spool in the direction of
the arrow on the spool. Make
sure to wind the line on
crisscross (figure O).
neatly and in layers. Do not
• When the wound cutting
line reaches the recesses (j),
cut the line. (figure P).
• Temporarily park the line in
the holding slots (k) on one side
of the spool as shown in the
inset in figure P.
• Repeat the above
procedure for the second
cutting line on the lower section of the spool.
• Fit the spool onto the tool as described in "REPLACING THE SPOOL".
O
P
j
k
Before you begin trimming, only use the
appropriate type of cutting line. Ensure that cutting line is present in
CAUTION:
both sections of the spool (figure M).
To avoid serious injury, switch off and unplug the
tool before performing any maintenance.
WARNING:
1. Keep the air intake slots clean to avoid overheating.
2. Your trimmer line can dry out over time. To keep your line in top condition,
store spare pre-wound spools or bulk line in a plastic, sealable bag with a
tablespoon of water.
3. Plastic parts may be cleaned by using a mild soap and a damp rag.
4. The line cutter on the edge of the guard can dull over time. It is recommended
you periodically touch-up the sharpness of the blade with a file.
IMPORTANT: To assure product SAFETY and RELIABILITY,
repairs, maintenance and adjustment should be performed by
authorized service centers or other qualified service organizations,
always using identical replacement parts.
k
10

MAINTENANCE