Sound Settings; Digital Output; Analog Output; Night Mode - Magnavox MRV640 Manual De Instrucciones

Sound settings

Depending on the audio outputs being used, this menu provides you with a selection of settings.
If you are only using the analog audio outputs (red and white L AUDIO R OUT , AUDIO
OUT jacks), select 'Off' in the 'Digital output' menu.

'Digital output'

You can select one of the following settings for devices that are connected to the DIGITAL
AUDIO COAX OUT jack:
'All' : Dolby Digital and DTS signals are going out unchanged through the digital output. MPEG-2
multi-channel signals are converted to PCM (Pulse Code Modulation).
Use receivers/amplifiers with a digital multi channel sound decoder.
'PCM only' : Dolby Digital and MPEG-2 multi-channel signals are converted to PCM (Pulse Code
Modulation).
Use this with receivers/amplifiers without a digital multi channel sound
decoder.
'Off' : digital output is off.
Use this if the Recorder is connected only to devices with an analog audio input.

'Analog output'

You can select from the following settings for devices connected to the analog outputs ( L
AUDIO R OUT , AUDIO OUT ).
'Stereo' : For devices that use neither DolbySurround nor TruSurround. Only use this setting
when the DVD Recorder is connected to a stereo TV.
'Surround' : Dolby Digital and MPEG-2 multi-channel are mixed to a Dolby Surround-compatible
two-channel output signal.
For devices with a Dolby Surround / Pro Logic decoder .

'Night mode'

Night mode optimizes the sound dynamics at low volume. This causes less disturbance in quiet
environments. This setting only functions with Dolby Digital Audio on DVDs.
User preferences
Sound
Digital output All
Analog output Stereo
Night mode Off
69