Blade Guard; Assembly; Operation - Parkside PTKS 1800 SE Instrucciones De Utilización Y De Seguridad

Preparing the device for use / Operation

Blade guard

:
2
The Blade guard must be in place whenever
2
you operate the saw.
Push stick :
12
The supplied push stick
to your hand when feeding the workpiece into the
saw (for use see fig. F).
Always use the push stick
the guide fence a and the blade
1
Safety ON / OFF switch with AUTO-OFF
The switch operates using an integrated low volt-
age relay. This means that the machine cannot
come on again automatically after a power supply
failure. The machine must be restarted using the
ON / OFF switch . The machine can be
16
switched off immediately by pressing down the
switch cover.
Overload switch / overload protection
(Reset ) (Fig. H)
17
If the machine is overloaded, the protection mecha-
nism automatically switches the machine off.
The machine can only be switched back on again
by first pressing the reset switch
ON / OFF switch .
16
j
If there is still an overloading problem, check
whether:
- very hard wood was being sawn too quick-
ly (feed speed)
- there has been a drop in speed / a rise in
power consumption
- very moist wood was being sawn (high
braking effect)
- the machine is choked with saw dust
- the saw blade is blunt
Vacuum dust extraction connection
& :
2a 20
j
If you are working in an enclosed space you
must use a suitable vacuum dust extraction de-
vice (see Fig. F). If you are not working with a
vacuum dust extraction device then the dust
will collect inside the housing and must be re-
moved after 30 minutes of operation (maximum).
36 GB/MT
serves as an extension
12
if the distance between
12
is ≤ 120 mm.
4
and then the
17
j
You can connect the vacuum dust extraction
device to the vacuum dust extraction connection
or the vacuum dust extraction connection
2a
or to both, as you like.
j
Connect a special vacuum extraction device or
a sawdust extraction system to the vacuum dust
extraction connection
extraction connection
j
Use the appropriate extraction adapters
and (see Fig. B).
22
:
16

Assembly

Q
j
Attach the blade guard
. The underside of the blade guard
3
be horizontal and lie flat on the saw table
workpiece with the saw blade
ly beneath it.
j
Mount the guide fence
guide into the guide slots
8
on the type of work you are doing.

Operation

Q
WARNING!
shown on the machine rating plate (equipment shown
as 230 V can also be connected to 220 V). The
electrical circuit must be fitted with 16 A protection.
Blade height adjustment:
The table saw has a patented
scissors-type height adjustment
mechanism. This allows the height
to be set precisely.
j
Set the blade height (cutting depth) by turning
the hand wheel
Setting the blade angle:
j
Release the safety lock thumb knob
j
Set the inclination angle of the saw blade
using the blade angle adjustment thumb knob
to any angle between 0° and 45°. The
18
desired angle can be read off the blade angle
scale . Tighten the safety lock thumb knob
15
and / or vacuum dust
2a
.
20
to the riving knife
2
moving free-
4
and / or the mitre
1
, depending
6
The voltage must agree with that
.
14
13
20
21
must
2
/
5
.
4
.
13