Connecting And Replacing The C0² Cylinder. Adjusting The Amount Of C0² - Columbia soda CS 18 TOP Manual De Instalación, Uso Y Mantenimiento

CAUTION
ES
Always replace the filter after the maximum time of use stated on the filter itself has passed, even if the
appliance has not dispensed the amount of water stated as the maximum filter capacity.
EN
5. CONNECTING AND REPLACING THE C0² CYLINDER. ADJUSTING THE AMOUNT OF C0²
FR
Remove the drip tray.
Remove the front panel from the front. Tilt the cylinder as shown in the figure and remove it from its position.
Close the regulator knob, turning it anti-clockwise.
D
Unscrew the cylinder from the regulator.
IT
PT
Tighten the new cylinder to the regulator using your hands only.
Open the adjustment knob, turning it in a clockwise direction.
Put it back in position, first the base and then the top part, securing it with the special C-shaped ring in the
holder.
To adjust the amount of C0², turn the knob on the regulator.
Turning it in a clockwise direction increases the amount of C0², while turning it in an anti-clockwise direction
decreases it.
Caution! The amount of C0² in the water does not change immediately, but only after dispensing a few times.
CAUTION
When unscrewing the used cylinder and while tightening the new one, gas can be heard escaping from the
cylinder for a moment: this behaviour is completely normal.
The C0² cylinder must be replaced when the supply of sparkling water decreases significantly or when carbo-
nation decreases significantly.
CAUTION
A reduced flow of sparkling water may be due to the C0² cylinder running out.
CAUTION
The appliance is normally equipped with a C0² cylinder which cannot be refilled.
For more detailed information about the collection systems available, contact your local waste disposal service
or the shop where the product was purchased.
For information about refillable C0² cylinders, contact your installer.
24