Esselte LEITZ ILAM TOUCH A3 TURBO Manual Del Usuario página 6

Overview of your laminator
Open out the front cover page where you will find a
diagram that you can keep for reference while reading
these operating instructions.
Input tray – Here you insert the pouch with the

document to be laminated centrally. This tray can
be folded in for space-saving storage.
Output tray – This is where the laminated docu-

ment exits. This tray can be folded in for space-
saving storage. You can also laminate without
folding out the tray when there is not enough room
at the place of action. In this case you must lead out
the laminated document diagonally upwards with
your hand so that it is not blocked.
Mains cord/plug – Connect this with a suitable
C
mains outlet. Read the safety precautions in this
manual.
Reverse button – This activates the manual re-
D
verse function. Use this, for instance, to prevent a
document that has not been inserted correctly from
being laminated further. Assist the reverse motion
by carefully pulling at the pouch. The READY indi-
cator blinks red while reverse motion is in progress.
The reverse motion ends as soon as you stop
pressing the button. Important: If the pouch has
almost entirely left the laminator through the output
tray, the transport moves on while pressing the but-
ton and no reverse motion is performed.
On/Off button – Use this to switch the laminator
E
on (button lights) and off (button does not light). If
no lamination is carried out, the laminator switches
off after 30 minutes (energy saving function).
Anti-jam recognition with automatic reverse –
F
Your Leitz laminator is equipped with sensors to
assist you in removing a pouch from the laminator
in case of an impending or actual pouch jam. The
following table shows how the laminator reacts in
certain situations.
6

Situation
During lamination
the pouch gets
stuck in the front
part of the lami-
nator.
During lamination
the user switches
off the device or
the mains power
fails or the device
is otherwise dis-
connected from
mains.
Important: Clean the rollers after any pouch jam as
described in section "Maintenance and care".
Thickness sensor with speed adjustment – Your
G
Leitz laminator is provided with a sensor which rec-
ognizes the thickness of the material to be laminat-
ed and adjusts the laminating speed accordingly.
By this, all approved materials from normal copying
paper to photographs, coated inkjet and laser pa-
pers are always laminated as good as possible.
Four-stage READY indicator – Three red lights
H
and one green light have the following meaning:
3 red lights
2 red lights
1 red light
Green light
3 red lights,
blinking
A red light coming up during the lamination process
means that the laminating temperature has dropped
too far or the sensors are being calibrated automa-
tically. This is normal behaviour. Just wait with the
next pouch until the green light comes up again.
Reaction
Automatic reverse is activated
and the pouch is driven out
through the input tray. Assist the
process by carefully pulling at
the pouch. As soon as the pouch
has left the front sensor area, the
laminator switches off automati-
cally to prevent the pouch from
being pulled in again. To laminate
another item, switch the device
on again.
After re-starting the laminator,
automatic reverse is activated for
30 seconds to drive out the pouch
through the input tray. As soon as
the READY indicator lights green,
you can laminate again as usual.
Heating up (approx. 5 min.)
Heating up (approx. 3 min.)
Heating up (approx. 1 min.)
Ready for laminating
Automatic or manual reverse