Publicidad
Idiomas disponibles
Idiomas disponibles
The highest SAR value for your TAG Heuer Connected Watch (at the
device's highest possible power level):
• when tested for use at the wrist was FCC SAR 0.0254 W/kg, EU
SAR was 0.03 W/kg.
• when tested for use at the trunk was FCC SAR 0.0678 W/kg and
EU SAR 0.0274 W/kg.
To disable the Watch's radio (including Bluetooth and Wi-Fi) functions,
please refer to section A. Main characteristics of your TAG Heuer
Connected Watch.
PART II: LEGAL INFORMATION
Important: required regulatory marks and certification in-
formation required in certain countries are provided on the
device under the settings. To access this information, go to:
Setting –> System –> about –> Regulatory information to ac-
cess information.
FCC / Industry Canada Notice
In compliance with Industry Canada regulations, technical speci-
fications have been provided in a declaration of conformity. This
does not imply that Industry Canada approved the equipment.
Caution: Changes or modifications to this handset not expressly
approved by the party responsible for compliance could void the
user's authority to operate it.
FCC Statement (USA) / Part 15 of the FCC Rules
The TAG Heuer Connected Watch has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruc-
tions, may cause harmful interference to radio communications.
However, there is no warranty that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or televi-
sion reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment to an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio or television technician
for help.
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) this device may not cause
harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
WARNING! Exposure to Radio Frequency Radiation: the radiated
output power of this device is below the FCC and Industry Canada
radio frequency exposure limits.
This device must not be co-located or operating in conjunction with
any other antenna or transmitter.
FCC requires the user to be notified that any changes or modifications
7
Publicidad
