Door And Drawer; Probe - Cafe C2S900M Manual De Instrucciones

Door and Drawer

Cleaning the Oven Door
Cleaning the Door Interior
Do not allow excess water to run into any holes or slots
in the door .
Wipe dish soap over any baked-on spatters on the glass.
wipe over the glass with a soapy cloth to remove any
residue and dry off.
The area outside the gasket can be cleaned with a soap-
filled plastic scouring pad. Do not rub or clean the door
gasket - it has an extremely low resistance to abrasion.
If you notice the gasket becoming worn, frayed or
damaged in any way or if it has become displaced on the
door, you should have it replaced.
Removable Warming Drawer or Storage Drawer
NOTE: For models with an electric warming drawer,
before performing any adjustments, cleaning or
service, disconnect the range electrical power supply
at the household distribution panel by removing the
fuse or switching off the circuit breaker. Make sure
the warming drawer heating element is cool.
Most cleaning can be done with the drawer in place.
However, the drawer may be removed if further cleaning
NOTE: To remove Push to Open Storage Drawer, push
the center of the drawer in and allow it to slide out.
To remove the drawer:
1. Pull drawer straight out
until it stops.
2. Press the left rail
release up and press
the right rail release
down, while pulling the
drawer forward and free.

Probe

The temperature probe may be cleaned with soap and
water or a soap-filled scouring pad. Cool the temperature
probe before cleaning. Scour stubborn spots with a soap-
filled scouring pad, rinse and dry.
To order additional temperature probes, see the
Accessories and Consumer Support sections at the end
of this manual.
49-2000636 Rev. 1
Cleaning the Door Exterior
If a stain on the door vent trim is persistent, use a mild
abrasive cleaner and a sponge-scrubber for best results.
Do not use this method on any other surface.
Stainless Steel Surfaces (on some models)
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy
water or a stainless steel cleaner or polish. Always wipe
the surface in the direction of the grain. Follow the cleaner
instructions for cleaning the stainless steel surface.
To inquire about purchasing cleaning products
including stainless steel appliance cleaner or polish,
see the Accessories and Consumer Support sections
at the end of this manual.
To replace the drawer:
1. Place the left drawer rail around the inner left rail
guide and slide it in slightly to hook it.
2. Place the right drawer rail around the inner right rail
guide and slide it in slightly to hook it.
3. Slide the drawer all the way in.
Do not immerse the temperature probe in water.
Do not store the temperature probe in the oven.
Do not leave the temperature probe inside the oven
during a self or steam clean cycle.
23