Unpacking And Assembly - elem MT60-139CC Traducción De Las Instrucciones Originales

PETROL SAFETY WARNINGS
WARNING: Use extra care when
handling fuels. They are
inflammable and the vapours are
potentially explosive. The
following points must be
Use only an approved container.
Never remove the fuel cap or add fuel when the
engine is running. Allow engine exhaust
components to cool before refuelling.
Do not smoke.
Never refuel the machine indoors.
Never store the machine or fuel containers in
places where there is a naked flame, such as a
water heater.
If fuel is spilt, do not attempt to start the power
source before moving the machine away from the
spillage area.
Always replace and securely tighten the fuel cap
after refuelling.
Whenever the tank is drained, this should be
done outdoors.

UNPACKING AND ASSEMBLY

Unpack cultivator
Carefully lift the cultivator out of the box, remove
any packing material and cut any ties holding the
handlebar pieces to the cultivator assemb
Assembly
Install the tines :
observed.
Place and align the tine assembly towards to the
shaft , then fix it by a column form pin and insert a
split pin on the column form pin to prevent it moving
out.
Install the wheel
Fix the wheel support assembly on the base using a
bolt and a nut,
then tighten it using a spring, and insert a B-shape
pin on the shaft to prevent the spring moving out
Install the handles
Place and align the handlebar arm on the base, and
fix it with 4 bolts.
Assemble the handlebar to the handlebar arm, fix it
with 2 bolts on each side.
Install the plastic cover on the handlebar. Fix it with
4 screws on the back side.
Connect the clutch cable to the handle.
Note: if it has been installed already, you need not
perform this step
14