Step 7: Electrical Requirements, Connection & Grounding - Thermador PROFESSIONAL PRO GRAND PRG364JDG Manual De Instalación

Step 7: Electrical Requirements, Connection & Grounding
MODEL
TYPE
36"
36" with Griddle
48" with Griddle
Before installing, turn power OFF at the service panel. Lock
service panel to prevent power from being turned on
accidentally.
A neutral supply wire must be provided from the power
source (breaker panel) because critical range components,
including the surface burner spark reignition modules,
require 120 VAC to operate safely and properly.
WARNING:
An improper 120 VAC power supply will cause
malfunction, damage to this appliance, and possibly
create a condition of shock hazard.
If the correct power supply circuit is not provided, it is the
responsibility and obligation of the installer and user to
have proper power supply connected. This must be
accomplished in accordance with all applicable local codes
and ordinances by a qualified electrician. In the absence of
local codes and ordinances, the power supply connection
shall be in accordance with the National Electrical Code.
English 16
CURRENT
VOLTAGE
120 VAC
120 VAC
120 VAC
FREQUENCY
RATING
15 Amps
20 Amps
20 Amps
Table 3: Electrical Supply Circuit Requirements
Observe all governing codes and ordinances when
grounding. In the absence of these codes or ordinances
observe National Electrical Code ANSI/NFPA No. 70
current issue.
Electric wiring diagrams and schematics are attached
behind the door trim of the range, for access by a qualified
service technician (see Figure 32 on page 25).
IMPORTANT:
For all gas ranges with electric griddle, dedicated 20 AMP
service is required for proper operation. Before you plug in
an electrical cord, be sure all controls are in the OFF
position.
For appliances equipped with a cord and plug, do not cut or
remove the ground prong. It must be plugged into a
matching grounding type receptacle to avoid electrical
shock. If there is any doubt as to whether the wall
receptacle is properly grounded, the customer should have
it checked by a qualified electrician.
INSTALLER — show the owner the location of the circuit
breaker. Mark it for easy reference.
PHASE
60 Hz. Single
60 Hz. Single
60 Hz. Single