Installation And Setup; Operation; Ozzymat - Chemfree SmartWasher 25 Manual De Operación

INSTALLATION
AND SETUP
Your SmartWasher is shipped fully assembled. (The OzzyMat,
support grid and false bottom of the sink are packed inside the
sink). Visually inspect for damage (minor scratches and scuffs
are normal due to the molding process).
The SmartWasher will weigh approximately 300 pounds (136 Kg)
when it is filled with fluid. It should be installed close enough to a
nominal 115 VAC (220 VAC), Ground Fault Circuit Interrupter (GFCI)
electrical outlet so that it can be plugged in. The SmartWasher should
be the only item plugged in to this circuit. Do not plug in before
adding fluid.
PARTS WASHER SETUP
1. Remove the false bottom and
check to make sure the mat
support grid is in the bottom of
the sink; remove any packing
materal from support grid.
2. Remove the OzzyMat from its
package, unfold it and lay it on
the mat support grid (white
side up).
3. Place the false bottom in
position in the sink.
4. Form the flexible nozzle to its
desired shape and be sure
that the parts brush is inside
the sink.
5. At start up, carefully add 25 gallons (five 5-gallon boxes) of
OzzyJuice to the SmartWasher by slowly pouring the
solution directly into the sink.
6. Plug the unit in to a 115 V (220 VAC) GFCI electrical outlet.
7. The SmartWasher will take approximately four hours to heat
up to its optimal temperature of 105° F (+-5°) (40° C) (+-3°).
This temperature will be maintained as long as the
SmartWasher is plugged in and full of OzzyJuice. (If the low
fluid light is on, the heater automatically shuts off.)
PARTS WASHER OPERATION
1. The pump switch is attached to a ten-minute timer. Turning
the switch ON (upward position) will start fluid flowing for ten
minutes. To restart the flow, turn the switch OFF then ON
again and the flow will restart for another ten minutes.
2. Adjust the valve at the base of the faucet to control the flow
of the fluid through the faucet. The valve at the base of the
brush controls the flow of fluid through the brush. Both
outlets can be operated independently or together.
OzzyMat – FL-3/FL-4
The OzzyMat traps sludge and dirt as
small as 50 microns. It works effectively
even when it appears dirty. At some
point, however, it will become saturated
and unable to pass fluid freely and
must be changed. The Smart Washer
has bypass openings located under the false bottom of the sink
to accommodate overflow when the OzzyMat is clogged.
False Bottom
REPLACING THE OzzyMat
(Must be done every 4 weeks!)
White Side
Up

OzzyMat

Mat Support Grid
CHECK LOCAL REGULATIONS
You may be able to dispose of your used OzzyMat as solid
waste or with your other absorbent mats.
IMPORTANT MAINTENANCE NOTE
The OzzyMat must be changed at least every 30 days or the
Ozzy microbes will lose their effectiveness!
1. Make sure the pump is
not running.
2. Lift out the false bottom
of the sink and lean to
one side.
3. Remove the soiled OzzyMat.
4. Remove a new OzzyMat from its poly bag, unfold it and lay
it on top of the support grid with the white side up.
5. Wring excess fluid on to new OzzyMat. It is important to
WRING used OZZYMAT prior to disposal.
6. Place used OzzyMat into the poly bag the new mat came in.
7. Dispose of used OzzyMat in accordance with local, state
and federal regulation
1