Getting Started; General Device Functions - auna Connect 120 Manual De Instrucciones

GETTING STARTED

Connection and Preparation
Connect the power adaptor to the back of device and plug it into power
socket. Switch on the device, it starts up.
Pull out the rod DAB/FM antenna for DAB and FM reception.
Connecting to the network
• A broadband connection in combination with a wireless access point,
router or similar network device.
• The network device needs to support WiFi (802.11 b/g/n) wireless
connection.
Make sure you have setup the wireless network and you have the WEP, WPA
or WPA2 security password to activate the connection. You may also use the
WPS (WiFi Protected Setup) function for easy pairing between the network
device and CMS 5000 BT DAB+ WEB. Check if the light indicators on the
network device are in appropriate status.
Connecting an audio source via AUX in
Use a standard RCA audio cable to connect the audio output from the
external device to the audio input sockets on the back of the device.
Connecting the headphones
Turn the volume down before using the headphones.
Inset the headphone plug (standard 3.5mm) into the headphone socket at
the front of the device.

GENERAL DEVICE FUNCTIONS

On the playing screen, rotate the volume knob or press
remote control to adjust the volume. Switch off the sound by pressing
the remote control.
Press MODE on the device/remote control to select modes.
Press MENU to open the menu. Press again to close the menu and return to
playing screen.
On the menu, rotate the knob or press / on the remote control to move
along the entries.
Press OK to confirm; press
step back.
on the device or on the remote control to

/ on the
on
EN
33