Fm Radio; Aux In - auna Connect 120 Manual De Instrucciones

FM RADIO

FM radio mode receives analogue radio from the FM band and displays RDS
(Radio Data System) information about the station and where broadcast.
To find a station, press OK (SCAN). The frequency display starts to run up
as the device scans the FM band. Alternatively, you can scan up or down by
pressing and holding the buttons / or tune manually with quick presses,
or by turning the reel.
Settings
• Scan settings : By default, FM scans stop at any available station. This
may result in a poor signal-to-noise ratio (hiss) from weak stations.
To change the scan settings to stop only at stations with good signal
strength, select 'Yes' after choosing 'Strong station only?'.
• Audio settings : All stereo stations are reproduced in stereo. For weak
stations, this may result in a poor signal-to-noise ratio (hiss). To play
weak stations in mono, select FM weak reception: Listen in mono only
and then YES.
BT
In BT mode, you can turn on the BT of your BT device. Go to the menu and
turn BT discoverable. From your BT device, search the radio 'CONNECT 120'
to pairing. When it is waiting for pairing, there is a blinking BT icon at the
bottom. If the pairing is successful, the BT icon becomes steady.
Control the music playback from your BT device.
Control the music playback from your BT device. Press / on the remote
control to go back to forward track or go to next track. Press
pause the track.
To disconnect from the radio, press and hold BT PAIR on the remote control.

AUX IN

AUX in mode plays audio from an external source.
Turn the volume low on both the radio and, if adjustable, the audio source
device.
Enter AUX mode, then adjust the volume as required.
to play or


EN
37