Installing The Ground Lug And Bracket Assembly - Dell S6010-ON Manual Del Usuario

Installing the Ground Lug and Bracket
Assembly
Install the ground (GND) lug and bracket assembly, with a ground wire
attached, before you install the S6010-ON switch in a rack.
Dell Networking supplies a kit with the following:
• One two-hole UL-certified GND lug
• L-bracket
• Two flat head screws (to attach lug to bracket)
• Two pan head screws (to attach assembly to chassis)
You must supply:
• A wire that complies with your local electrical codes in size and color
(typically the wire is 14 AWG, colored green or green with a yellow stripe).
• An anti-oxidant compound (Dell Networking recommends NOALOX 4 or
equivalent).
• A crimping tool.
• A thread-locker compound (Dell Networking recommends Threadlocker
Blue 242 or equivalent).
1. Attach the end of the ground wire to the GND lug:
a. Coat the bare end of the wire with an anti-oxidant compound.
b. Insert the end of the wire into the lug.
c. Crimp the lug end to secure the connection of wire to lug.
7