Tabla de contenido
Publicidad
6.
Install the Wall Jambs and Top Track
Screw Cover
Cache vis
Cubre tornillo
#8-18 x 2" Panhead Screw or
Vis à tête ronde #8-18 x 2" ou
Tornillo de cabeza redonda #8-18 x 2" o
Install the Wall Jambs
Place a wall jamb over the bottom track. Align the holes in the wall jamb with the
holes in the wall.
NOTICE: For tapered wall jambs: Use the #8-18 x 2" panhead screws (supplied). For
non-tapered wall jambs: Use the #8-18 x 1-1/2" panhead screws (supplied).
Insert a bumper through one of the correct length panhead screws.
Using the panhead screw with bumper, secure the middle of the wall jamb to the
wall. Do not overtighten the middle screw, as damage to the bumper may occur.
Using the correct length panhead screws, secure the top and bottom of the wall
jamb to the wall.
Repeat these procedures for the remaining wall jamb.
Install screw covers over the top and bottom screws in each wall jamb.
Install the Top Track
NOTE: The top track is designed so either side may be positioned facing outward
according to your preference.
Measure the distance from wall to wall above the wall jambs.
Mark the top track at the determined dimension.
NOTE: For best results use a 32-teeth per inch hacksaw and miter box.
Cut the top track on the inside edge of the mark [approximately 1/32" (1 mm)
from the mark] to allow space for the top track to slide into place easily.
Carefully file the rough edges smooth where the top track was cut, taking care to
avoid damaging finished surfaces.
Position the top track over the wall jambs and gently push down.
1063220-2-G
Measure here.
Mesurer ici.
Mida aquí.
Top Track
Rail supérieur
Carril superior
#8-18 x 1-1/2" Panhead Screw
Vis à tête ronde #8-18 x 1-1/2"
Tornillo de cabeza redonda #8-18 x 1-1/2"
14
Sterling
Publicidad
Tabla de contenido
