End Of Operation - Taski swingo 350B Manual De Instrucciones

End of operation

• Press the cleaning solution button.
The cleaning solution supply is
stopped.
• Drive on for a few meters in order to absorb the remaining
drain water.
• Release the operating lever.
• Now turn the suction unit and then
the machine off, or just turn the ma-
chine off if the suction unit should be
turned on immediately when the ma-
chine is turned on again. (See page
70: One-button function)
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and disconnect the battery discon-
nection socket before beginning with the
following steps.
Removing and cleaning the squeegee
• Place the machine on the parking
A
support.
A: For traction batteries; use the
parking support on the right
B: For lithium-ion batteries; use the
parking support on the left
B
• Remove the squeegee by turning the
locking screws.
• Clean the squeegee under running
water using a brush.
Notice:
Only cleaned and intact blades ensure op-
timal suction results!
Empty and clean the recovery tank and fresh water tank
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation-
al regulations.
Notice:
When draining the recovery tank, the reg-
ulations of the detergent supplier regard-
ing personal protective equipment must be
observed.
72
Empty recovery tank
• Open the tank lid.
• To drain the recovery tank, remove
2
the sieve (1), turn the lid (2) to the
3
side and then lift the tank from the
1
machine.
The tank can be completely drained
via the drainage hole (2).
Empty fresh water tank
• To drain the fresh water tank, you
have to remove the filter.
Cleaning the recovery tank
• Open the tank lid.
• Remove the solids filter (yellow) and
empty it.
• Rinse the filter thoroughly under run-
ning water.
• Remove the recovery tank from the
machine.
• Thoroughly rinse the recovery tank
with clean water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
Attention:
Clogged suction filters may impair the suc-
tion performance.
• Refit the rubber cap to the recovery tank.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Screw the lid of the drain opening shut again and press it
into the opening until it locks.