Troubleshooting - Urrea CN1106 Manual De Usuario Y Garantía

4. Rotate the cutterhead pulley to give you
good access to one of the cutterhead knives.
5. Loosen the cutterhead gib bolts, starting in
the middle and alternating back-and-forth un-
til all of the gib bolts are loose but not falling
out.
· If this is the first time you are setting the
knives, or if you are replacing them, remove a
gib and knife from the cutterhead. Clean the
gib and clean inside the cutterhead slot to re-
move all pitch or sawdust. Coat the knife and
gib with a metal protector.
6. Position the knife gauge over the knife as
shown in Figure 58 and loosen the gib bolts
until the knife is completely loose.
7. Using a 2.5 mm hex wrench, rotate the jack
screws (Figure 58) in the access holes to raise or
lower the knife. When the knife is set correctly,
it will barely touch the middle pad of the knife
setting jig. Snug the gib bolts tight enough to
just hold the knife in place. Repeat Steps 5-7
with the rest of the knives.
8. Rotate the cutterhead to the first knife you
adjusted. Slightly tighten all the gib bolts, start-
ing at the middle and working your way to the
ends by alternating left and right (Figure 59).
Repeat this step on the rest of the knives.
9. Repeat Step 8, but final tighten each gib
bolt.
10. Adjust the outfeed table to match the new
knife heights (refer to Setting Outfeed Table
Height).
11. Replace the cutterhead guard and the rear
access panel.
CALIBRATING INFEED TABLE
The infeed table height is calibrated by adjust-
ing the depth scale and depth stop knob.
34
CALIBRATING DEPTH SCALE
The depth scale on the infeed table can be cali-
brated or "zeroed" if it is not correct.
To calibrate the depth scale:
1. Set the outfeed table height as described in
Setting Outfeed Table Height.
2. Move the cutterhead guard out of the way.
3. Place a straightedge across the infeed and
outfeed tables.
4. Adjust the infeed table until it is level with
the outfeed table, as illustrated in Figure 60.
5.
driver, adjust the scale
pointer exactly to "0",
as shown in Figure 61.

TROUBLESHOOTING

Fig. 58 MOTOR AND MACHINE OPERATION
MOTOR WILL NOT START
Low voltage. Check power line for proper voltage.
Open circuit in motor or loose connections. In-
spect all lead connections on motor for loose
or open connections.
FUSES OR CIRCUIT BREAKERS BLOW
Short circuit in line cord or plug. Repair or re-
place cord or plug for damaged insulation and
shorted wires.
MOTOR FAILS TO DEVELOP FULL POWER (OUT-
PUT OF MOTOR DECREASES RAPIDLY WITH DE-
CREASE IN VOLTAGE AT MOTOR TERMINALS)
Power supply circuit overloaded with lights,
appliances, and other motors. Reduce load on
circuit.
Undersized wires or circuits too long. Increase
wire sizes or reduce length of the circuit.
Using a screw-
Fig. 60
Fig. 61