GE Monogram ZDT800 Serie Manual De Instrucciones página 23

Before You Cull for Service
Dishwasher
Questions?
Use this
problem
solver
PROBLEM
Start status
indicator light
flashing
Dishwasher
BEEPSonce
every minute
Display
shows "LEAK
DETECTED"
Beeping at
the end of
the cycleIon
some models}
Dishesend
flatware not
clean
POSSIBLE CAUSE
WHAT TO DO
Thedoor WaS openedor the
cyclewas interrupted.
This is e reminder that your
dishwasherdoor has been left
open during operation. It will
continue beeping until you
pressSTART end close the door.
Possibleleek is detected
• Press the START button onceand closethe door to start the
dishwasher.
° Press the START button a secondtime whenthe dishwasher i s
runningonly if you wish to cancel the cycle.
• Press START and closethe door.
• Somemodelsare equippedwith leakdetectionand the cycle
will be cancelled if a leakisdetected. T hedisplaywill show
"LEAK DETECTED". Call f or service.
This is normal. The
dishwasher will beep twice at
the end of the cycle.
• Toturn off the doublebeepindicator(orre-activateit if it was
previously turned off), pressthe Heated Dry button 5 times
within 3 seconds.A triple beepwill soundto indicate the
end-of-cycle beep option has beenturned on or off.
Ultra Fineor Finefilteris • Seethe Careand cleaningsection.
clogged
Lowinlet water temperature ° Makesureinletwater temperatureiscorrect(seethe Usingthe
dishwashersection). Turnonthe hot water faucetnearestthe
dishwasher, l etrun untilthe water temperaturestopsrising.
Thenstartthe dishwasherand turn off the faucet.Thisensures
the enteringwater is hot.SelectBoostTemp.
Water pressureis temporarily ° Turnon a faucet.Is water comingout moreslowlythan usual?If
low so,wait untilpressure isnormalbeforeusingyourdishwasher.
Air gap or disposeris clogged • Cleanthe air gap or flushthe disposer.
Improper rack loading • Makesurelargedishwaredoesnot blockthe detergent
dispenser or the wash arms.Seethe Loadingthe dishwasher
section.
Poorperforming detergent • Usea highlyrated detergentsuchasCascade®Platinum
Pacs.
Leakdetected • Somemodelsare equippedwith leakdetectionand the cycle
will be cancelled if a leakisdetected. T hedisplaywill show
"LEAK DETECTED't Call f or service.
Spotsand Extremelyhard water • Userinseagentssuchas Cascade ®CompleteRinseAid to
filming on preventspotsand preventnewfilm buildup.
glassesand ° If water is extremely hard, a softener may be required.
flatware • Makesurewater temperatureisat least120°F (49°C).
• Loaddishwasher a s shownin the LoadingPlaceSettings
section.
• Makesuredetergentisfresh.
• Refill w ith rinseagentsuch asCascade ®CompleteRinseAid.
• Makesureyou usethe properamount of highlyrated detergent.
Low inlet water temperature
Overloading or improper
loading of the dishwasher
Old or damp powder detergent
Rinse agent dispenser empty
Too little or low performing
detergent
23