Thermador MASTERPIECE ME301JP Manual De Instrucciones página 28

Removing the Oven Door
9
CAUTION
WHEN REMOVING THE OVEN DOOR:
Make sure oven is cool and power to the oven
▯
has been turned off before removing the door.
Failure to do so could result in electrical shock or
burns.
The oven door is heavy and parts of it are fragile.
▯
Use both hands to remove the oven door. The
door front includes glass components. Handle
carefully to avoid breakage.
Grasp only the sides of the oven door. Do not
▯
grasp the handle as it may swing in your hand
and cause damage or injury.
Failure to grasp the oven door firmly and properly
▯
could result in personal injury or product damage.
To avoid injury from hinge bracket snapping
▯
closed, be sure that both locking levers are
securely in place before removing the door. Also,
do not force the oven door open or closed - the
hinge could be damaged and injury could result.
Do not lay the removed door on sharp or pointed
▯
objects as this could break the glass. Lay the
door on a flat, smooth surface, positioned so that
the door cannot fall over.
To remove the oven door:
1. Read the preceeding caution notice before beginning
the oven door removal process.
2. Provide a nearby place to safely lay the door after
removal so it will not fall over or be stepped upon. Lay
the door flat on a blanket or cushioned surface.
3. Open the oven door fully until it is parallel to the floor.
The door contains powerful springs to assist with
closing the door. It is necessary to position the toggle
locks in place to take the tension off the springs.
To access the toggle locks, remove the locking plate
4.
using a T20 star head driver.
28
After removing the screw, (A) lift the locking plate up
5.
and then pivot it out to remove. Repeat for the other
hinge. Retain both locking plates and screws for
reinstallation.
Flip the locking levers towards the door as far as they
6.
will go. Hint: (B) It may be helptul to use the tip of a
screwdriver to pull out the locking levers. (C) Make
sure both locking levers are in the locked position
pushed all the way towards the door.
7. With the toggles in place as shown, carefully close the
oven door until the front side of the door is about
5½ inches (140 mm) from the control panel.
8. Grasp the door firmly using both hands. The door
weighs over 30 pounds.
9
CAUTION
To avoid damage do not allow the door to strike
the control panel during door removal or
replacement.