Setting The Time And Date Manually - ADE WS 1917 Instrucciones De Operación

No data display from the wireless outdoor sensor
1. Check whether you have inserted the batteries
correctly.
2. Check whether the location of the outdoor sensor is
suitable, see "Choosing a location".
3. Press and hold
to the outdoor sensor.
4. When using a single wireless outdoor sensor
(standard), transmission channel 1 is usually used
for data transmission.
‚ Press the button
in the display.
‚ Then, if necessary, check whether the sliding
switch on the wireless outdoor sensor is also
set to „1".
Note: You can also use any other transmission
channel. However, it must be identical for the base
station and the outdoor sensor.

Setting the time and date manually

If there is more than approx. 30 seconds between
two pushes of a button, the setting process
automatically ends and you will have to repeat it.
1. Keep the
symbol and "ON" or "OFF" flash on the display.
62
to manually start signal reception
button pressed until the radio tower
repeatedly until is shown
WS 1917 weather station