Installing The Interface; Initializing The Interface - Metra 99-9714WR Instrucciones De Instalación

INSTALLING THE INTERFACE

It is highly advisable to read the following steps beforehand, to ensure a clear understanding of
what is to be expected. The following steps must be done in the order that they are numbered.
With the key in the off position:
1. Connect the 99-9714WR harness into the interface, and then to the wiring harness in the
vehicle.
2. Connect the LCD screen into the interface.
3. Connect the 44-UA20 (provided), and complete all necessary connections to the radio.
Metra recommends using the proper mating adapter from Metra.
4. Do not connect the ASWC-1 just yet, leave it disconnected.
Attention! To prevent error codes, all electronic devices including the headlight and turn
signals must be connected before proceeding to the next step.
8

INITIALIZING THE INTERFACE

Attention! If the interface loses power for any reason, the following steps will need to be
performed again.
1. Turn the key to the ignition position and wait until the radio comes on.
Note: If the radio does not come on within 60 seconds, turn the key to the off position, disconnect the
interface, check all connections, reconnect the interface, and then try again.
2. Program the LCD screen:
a. Pull the screen protector from the LCD screen.
b. Press and hold the "Return/ESC" button on the LCD screen for 5 seconds until "Select Interface"
comes up.
c. Select "Connection Type", and then press "Enter"
d. Scroll up or down to "Direct Connect", and then press "Enter"
e. Once done, press "Return/ESC" to back out of that mode.
3. Test the radio and LCD screen for proper operation. Refer to "LCD Operation" for further information.
4. Turn the key to the off position.
5. Connect the ASWC-1 and then program it:
a. Turn the ignition on, the LED will start flashing rapidly.
Note: If the LED did not start flashing rapidly, press the reset button for 3 seconds .
Continued on the next page
|
386.257.1187 MetraOnline.com